- Видео 70
- Просмотров 242 110
Hardbody
Добавлен 13 апр 2013
Formally 1uz-Fe v8 Swapped
Now 4.8L Vortec Swapped
Now 4.8L Vortec Swapped
Slammed Nissan Hardbody UEL Header burnout
Summer. spring and fall have come to an end.
Просмотров: 1 081
Видео
Nissan Hardbody Unequal length header p2.2
Просмотров 6612 года назад
Nissan Hardbody Unequal length header p2.2
Nissan Hardbody Unequal length headers
Просмотров 2,7 тыс.2 года назад
Nissan Hardbody Unequal length headers
Nokian Nordman 7 RWD Snow tire test. (BEST budget Snow tire)
Просмотров 9 тыс.3 года назад
Nokian Nordman 7 RWD Snow tire test. (BEST budget Snow tire)
1uz Nissan Hardbody 2 step Bee R Rev limiter
Просмотров 35 тыс.4 года назад
1uz Nissan Hardbody 2 step Bee R Rev limiter
ITS PERFECTLY ADEQUATE
STOP TRYING TO GET ME TO BUY A 90S JAPANESE V8! MY KA24E IS JUST FINE!!!
Homeboy using diesel and dove soap 😂
😂😂😂
this shit is amazing lol been wanting to do a swap but might end up just rebuilding the ka i have sitting in my backyard to handle a turbo just want a little more beans than it gives
@ironwolf_6559 turbo KA is definitely the most cost effective route IMO. There is enough knowledge on the internet with a basic walk through on how to reliably make a good amount of power. anything custom like this becomes a massive financial headache LOL
Hey i have the same truck, i have a rod knock any tips?
@Luxcarz just pop another ka in it man. These trucks are awesome. But unless you have tons of $, a very strong mechanical ability & a ton of tools. I wouldn't recommend a motor swap. I have another one of these trucks with over 300k miles.
🎶🎶🎶🎶🎶
what’s your exhaust setup? did you only do a muffler delete?
@robonlean cut the exhaust right in the middle. Did 2.5 inch from that point back. Made a y pipe just like factory was. Just no mufflers
I’m looking to do this swap rn. What’d you have to do to make it fit? How well did the trans fit attached to the 1uz with adapter plates? Did you go with Collins? lol so many questions. ❤
Message me on IG @Flatbedhardbody will try and give as much info as I remember. Trucks LS swapped now
Can I get the spec bro I wanna do it like rn
@@MasenSilva what do you mean
@@4.8Flatbed what kinda rear end yo got in there
@MasenSilva still factory rear end. Has now gone through 7 years of being 1uz swapped and now 4.8l "LS" swapped
Is this diluted or full strength?
@@Slanovich 4:1 product is not to be used full strength.
Where did you get the wire harness from
Really don't care.
@@jimwilliams7136 cared enough to waste your time commenting 😂
Maybe think not every video is intended for you?
Clearly ya do
Most reliable v8 known to man
@brandonaguilar7841 hahah I don't disagree 🤣 but I've actually blown up 3 1uzs LOL
@@4.8Flatbedbruh how😂😭😭
Buster..from Ardex is way better
Ain't no one playing 5k for an ls400 You can still get them under 1k. 2-3k for a straight body.
@Alex-vz2jz not in new England. They are much more attainable in the south /California as that is where they were marketed. 2-3kwill get you a 250k mile beat interior ls400 around me.
So when I purchased dark fury it didn't say to dilute. Am I supposed to? What's your take on it?
@vancat11 did you buy a bottle like this? Or a gallon? This is pre diluted already (personally I think they dilute it more than 4:1 in these pre made bottles) but unless you bought a gallon. The pre made bottles are RTU. Hope this helps.
@4.8Flatbed I purchased a bottle from O'Reilly to try out. I was amazed on how well it worked.
@vancat11 that stuff is RTU. No need todilute!
What did you use for headers
@chevyon22joe some cheap Amazon ones lol Exhaust is 100% custom stainless steel with a magna flow muffler.
@@4.8Flatbed do you remember which ones
@@chevyon22joe Visit the Store, ECCPP ECCPP Visit the Store 4.3 22 Stainless steel Turbo Exhaust Manifold header Fits for 1999-2003 CHEVY/For GMC 800 V8 OHV HDSCC99SHORTY
@@chevyon22joe says they are currently unavailable but search that on amazon!
Which J series engine is it?
Dark fury diluted a bit more like 1:6 used over the entire car pulls that stubborn greasy dirt off. If you have a ceramic coat, it's like adding a new layer because it cleans up the coating so much.
Jesus Christ
What ratio? Or did you do full strength?
4:1 never full strength. You can go anywhere from 4:1 and up. Depending on condition
@@4.8Flatbed right on!!!@
ZOINKS Scoob A Miata that moves!
Folks keep in mind that wasn’t even a pressure washer that was a garden hose.
Crazy right lol
How much did it cost to do this? I’m thinking about doing this with my Miata and Odyssey
Rip oil pressure 😅
Hahahah cars still rippin
@@4.8Flatbed ye man, keep it goin
Are you using original transmisión?
Yes this was the ka24e 5 speed. Standard trams
Both are too alkaline, I say this as a chemist and product manufacturer, over time it ruins the rim and, moreover, they cost a lot for what they are made of, so washing the surfaces doesn't go as well.
Too alkaline will ruin the rims over time, I say this as a chemist, washing and ruining the surface over time is absolutely not good
I agree at 4:1 (as recommended) but at 10:1 is what the pro detailers use it at and its safe at that dilution.
Too alkaline, the rims can't be washed, thus ruining the clearcoat and then the paint. As a chemist and manufacturer of products, wash without ruining them. @@JulioBlanco50
Chemists make these. I think they consider things like that 😂
So glad I’ve been following detailing channels lol. Learning all the best secrets of the trade.
An even better secret is you can buy this in gallon jugs. Pour it into a 5 gallon bucket. Add 4 more gallons of water. And you now have 5 gallons of this pre made 🤝
@@4.8Flatbed sir, one step further and you’ll become a legend. To do this, you must now answer one more question. Where do we purchase the gallon size product from?
@BoofyBoyo O'Reilly Ask them for a Gallon of Dark fury. They probably will have to order it. I believe it is Stock number #C66-1
@@4.8Flatbed thank you bunches for the tips! I’m having a hard time competing with everyone on the usual classifieds. Any idea what to do about the crazy under cutters and the saturation?
@BoofyBoyo it's tough just have to price yourself to where you will get work but also make money. Until you build up a clientele. Let your work speak for itself. I get people who question my prices. And I also get people who don't even ask what I'm going to charge them. Detailing is a luxury.
Looks like it has a acid in it
Dark fury is extremely alkaline. Completely opposite of an acid. It's Completely safe on paint (as long as it's cool & doesn't dry.
Those zep bottles are thee worst sprayers ever
😂
True and tolco sprayers well all of them.
WHAT!?
A lot of superior products are amazing
Which ones do I want to avoid?
@@TXAslingr honestly I’ve used dark fury, formula spray wax, cherry soap, wash wax soap, green all, zap it, their bug cleaner can’t remember the name - aqua glosss - to be honest the only thing I didn’t like was cover all their tire dressing
@@TXAslingr maybe cover all
@@Thelab3314 I'd like to try them without buying mass quantities. The local O'Reilly doesn't sell any Superior products. Thanks for the info!
@@Thelab3314was aqua gloss good?
What in the world is a clapped car?
Just beat up & not maintained lmao.
@@4.8Flatbed I see and yeah I feel bad for people over paying anything.
I paid 900 for mine, exact same color. 1990 Gen 1, only 225k. Still rides amazing and everything works.
I also have a white gen 1. 270k Miles in very good condition
@@4.8Flatbed nice. I knew a guy that had two sc400 and two ls400 gen 2. I told him he'll never drive 4 million miles, he should share the wealth.
I need that. Where to buy???
You can get it a ORiley’s they sell them in different sizes. Really good product tho but depending on how caked on the break dust is you will have to scrub it.
Yo wad up
What's up 🫡
Can i fit that in my Sentra?
Absolutely
I appreciate the fact that someone on this planet was crazy enough to probably spend more on an mx5 base and the parts to fabricate an f series in it than an actual S2K would cost
Dawg swapping a Miata with a J motor is super cheap and actually easy to do.
@@Openup0911facts
Where can i buy this? This stuff is like flash royal brown but they must have discotinued royal brown cause i cant fins it anymore.
It's sold as Dark fury now, I've seen it at autozone. But it's always at O'Reillys
@@4.8Flatbed thank you
@@luiscasillas9853 no problem
I must have purchased a fake one at O'Reilly....because it did absolutely nothing on my wheels. I like nothing
So when I bought mine, I would buy it in the gallon / 5 gallon jugs because I owned a detailing business. I'm not sure how the pre made bottles are cut. Would be unfortunate if they changed the formula. As this video is like 5+ years old. Before the name was changed from Rage to Dark fury
Still active? Whats your ig, i have some questions
Congratulations now you can keep up with my bone stock truck
That will crash going 50 mph around a turn.
no scrubbing is crazy
Damn just literally shows that drive trains don't matter as long as you got good tires especially snow tires.
100%
I need help to connect
Those stickers 😢
Gonna try these on my 09 VW rabbit lol
Should be great. Especially being fwd!
Transmission???
thanks for the time its a sweet truck man