Видео

Do you need any coding for these ?

It's nicer to see what the old oil filter looks like, i.e. if it really removed the gunks in the engine. Otherwise it's a helpful video.

Did the reverse light work bro

I doubt it works. I just shredded a belt with a guard.

Your oil always gets darker the longer you drive it between oil changes. The oil that came out was barely used. Maybe halfway though its service life.. There were no clumps or bits of carbon that showed on your examples which shows the engine was in very good working order. The GDI engines are no stranger to getting buildup in the intake but as long as the seals and rings are good, the oil will only discolor from the heat it contends with. My 2002 pickups oil looks the same as your demonstration at every service interval. It's about changing oil regularly and on time if not a bit early. Ultimately, that is what will prevent premature wear and other issues in the long run

What if instead of pouring the Liqui Moly engine flush into the old oil and then rinsing the engine with the cheap oil you empty the old oil first, then do the Liqui Moly Engine flush with the cheap oil?

Nice bro that’s an exciting kit! Any idea where you’re gonna get it custom tuned? Or are there OTS maps? I’m gonna be doing f10 m5 calipers+m2cs rotors on the F36 in the next couple weeks

i bought the same, but i have wired it just like you but the flashes only works when i have my ignition on, when i start the car i dosent work anymore. really wierd do you have any thoughts?

anyone know why my turn signals aren’t sequential?

I hope you turned the heat and fan all the way up

No logs yet?

How many miles you have driven with the intercooler?

This is a waste of time and money.

U should have pulled the dip stick of the fresh oil cause that could be brown also

What is the name of this red light in the lower center?

16:08 homie got that mean coke nail

Way overcomplicated. You put it in an engine that is already at full operating temperature, idle for 15 min, and change the oil. It's not rocket science and this is a pointless waste of oil.

Hey bro installed the same spring on my f30 435i and damn nightmare my car has excessive sway or swirl when I go over any bump or pothole idk what to do

How many cans do I need for a V8 5.7litre Engine. Truck uses 8litres of oil.

Broh, what wheels and specs you have? Looks nice👌🏼

i do first drain oil and add chipp one with flash and replace with new oil

If you’re going to weld it, do you try to tack it up in-place then remove it cat back to finish the job? Or do you remove the old exhaust and cut and weld it in the bench ?

Also you can use the brown wire as a ground works perfectly

Very nicely explained video. Although I stopped the red wire and yellow wire around to get the break force light to work properly

Hi! How does the adaptive suspension feel? Didn't break? There is very little information on replacing springs on adaptive dampers, everyone is changing them to their normal sport counterparts...I have a 340 xdrive with adaptive m suspension t I don't know if it would be safe...only I want to put 05-22/06-22

Just change your oil regularly and us a good quality oil and you'll never have to do an engine flush.

Motomaster is actually good oil, its basically rebranded Pennzoil from Shell...💯👍

Thinking about buying these have they given you any issues so far?

I would only ever recommend ever doing this if you have an older, high mileage vehicle and you're unsure or know oil changes haven't been done on time and it has issues like oil burning or other performance issues. If oil changes are done on time using a good quality oil, you should never need to do this because the detergents in the oil are good enough to keep the engine clean over the long haul which prevents sludge buildup.

U didn't even need to take out the strut or use spring compressor there's a much easier way anyway did you have to ailgn your front wheels after your new springs

Did this fits on f31 as well? 😊

what size pipe would you suggest if i were to weld it

To be thorough, drain oil, put in cheap oil with flush. Drain and put cheap oil in again and a second can of flush. Drain, put in cheap oil again. Drain that out and put in Amsoil 5/30 Signature Series. So you will need 3 rounds of cheap oil and 3 filters and then the last round of the good stuff with a good filter.

Looks good !

You're rich. You're wasting time and money.

how was the aliexpress intercooler couldnt find a second video

And thé black where is connected on your video

I've seen online that, it's not good to do full engine flush with a car you have no history of oil change maintenance because filters in the engine might clogged up. They say, you wanna do it slowly with frequent oil change intervals. Maybe a little additive like gumout or seafoam before oil change would help it.

What up fam we got the same last name I always say what’s up when I see someone with same last name, The fam huge hahaha I just ordered The coils for my car too

This intake instantly set fault code 102001 faulty air mass on my 435 (no check engine light). Caused strange shiftings as well, had to go back to my factory intake. I could see from the logs there is about 4g/s difference of air flow on idle betwen stock and Injen. ”Tuned intake” is a scam. Quality unfortunately is garbage. The heat shield does not even seal against the bonnet and there was a lot of overspray paint inside the pipe which i don’t want in my engine. Only plus is that it make sounds.

Hi , i am doing the same on bmw f10 2013 , I wanna do in the driver side, can you please tell me what color of the cable is the brake light. My diffuser brings 3 cables black , re, yellow.thanks

CALL LIQUIMOLY TECH SUPPORT. YOU ARE WASTING YOUR TIME AND MONEY. SILLY PERSON YOU ARE. NAIVITY TO THE ENTH!!!😅

You do it wrong bro try this you drain the old oil n after put cheap new oil n engine flush n it will clean properly the engine trust me they do this technique in Arabia saudia n car ran forever

U made a mistake. U first need to start the car and then put the Flush otherwise all your liquid goes down to the oil tank. I guess u didn't read well.

Awesome vid bro

Does it fit on a f10 ?

Any oil will go brown or black after it reaches 00°, it don’t matter the 1 mile or 5k miles.. fit time it gets hot it goes brown!

They are not flushed you have to break off a piece near the wirer

But the product is AMAZING!

I just did it. And YES DO A SECOND WITH EXTRA FILTER. My second oil was black. Then finial oil and filter