Видео

A look at the regulator in the Stoeger xm1 rifle. Part 1 of full stripdown and rebuild of the XM1 , the object of doing this is to try and improve accuracy and shot count. I'm in the UK and will be keeping the power output to below 12 FT/LB, Before you do any work on a PCP remove all the air. This is my first time striping and adjusting a regulator.

A quick measure up of the barrel to scope height needed for the ballistic app The measurement you need for the app is centre of barrel to centre of scope. Get it as close as you can ,then adjust the height in the app when you start testing .

A quick 6 shots at 50 meters using the arken zulus ballistic scope. A main group of 20mm with one flier :( hoping the groups will improve as the barrel leads in ! Air Arms S510R .22

Altering the values in the ballistic App to get the pellet exactly on the mark, by adjusting ballistic coefficient of pellet and scope height . When you make an adjustment in the App hit the SAVE button. Link to Ballistic App setup ruclips.net/video/PvUeKJOAEx4/видео.html

Setting up the ballistic app and transferring the BC table to scope. A look at the menus and which setting to use . Selecting your pellet and adding to your profile. If its been useful to you hit the like and even subscribe :) thanks for watching

A step by step guide of setting up the zero . This is a demonstration run of setting up the zero, I'm using my phone attached to the Zulus , tried doing this outside while shooting but just couldn't see screen well. Picture is not the best but hopefully you'll get the idea. Comment ,like and subscribe would be great :)

Six different pellets tested on a second hand RM8 UC. at 24M Trying to find the best pellets .Starting by just looking at group size. Shooting off a bipod. First impressions of the RM8 are good. Might have to remove the automatic safety, I do forget about it .

Finishing off the B3, putting the trigger in and fitting to stock. on the chrono its putting out around 7 ft/lb , that's fine for what I want. New seals and spring would probably improve it but I'm happy with it as it is at the mo. Its just for a little plinking .

The old B3 has had a clean and the stock varnished. Time to put it back together, this will be in two parts video started getting a little long .

First time out with the Arken Zulus 5-20 , trying to get a feel for using the unit. No shooting done. Excuse the wobble at times, I was holding freehand and in freezing conditions and trying to remember where the buttons were. IR was on auto for the whole time and in flood position, didn't adjust for the long distance. For a first outing I'm pleased with how I got on with it.

Snowpeak B3 rifle renovation /clean-up . part 1 -strip down and clean . #B3 #chineserifle #snowpeak #oldrifle #underlever

Fitting a generic adjustable bipod to the XM1 . I think the side mounted legs make it too wide. These generic bipods can be a cheap buy. #xm1 #pcp #bipod

Fitting a bipod stud to my Gamo Phox MK2 ,

Stoeger XM1 , part 3 ,shot count.

Stoeger XM1 , part 2, New Transfer port , low power fix !

Stoeger XM1 , part1 strip down, low power fix !

Sunrises over the Snowdonia and Menai straits

Bipod stud fitting, Kral NP-02

GS 500 first start up after rebuild

Stoeger XM1 .22 ,pellet testing

Fox in the garden, a few clips caught with trail camera.

BSA shooting rest bags.

Vastfire , Adjustable focus hunting light for air rifles .

Porto Santo Beach

Air Arms S510r breach seal removal and replacement.

Sunrise over Snowdonia and Menai straits ,

Flagstaff quarry ,Penmon Anglesey .

HT-X 3006 chronograph. voice and wifi .

Gamo Phox MK 2 Trigger improvement / adjustment