- Видео 93
- Просмотров 138 296
INTHEMEAT
Добавлен 12 июл 2021
If im not in the woods or water then im not happy🦌🎣 I’m just some old country boy who lives to hunt, fish, and protect his country.
HALIBUT FISHING IN VALDEZ ALASKA *SHOTS FIRED* (FULL VIDEO)
HALIBUT FISHING IN VALDEZ ALASKA *SHOTS FIRED* (FULL VIDEO)
Просмотров: 1 202
Видео
ASCEND 133X TOURNAMENT KAYAK WATER TEST! (WITH SUPRISE CATCHES)
Просмотров 4592 месяца назад
ASCEND 133X TOURNAMENT KAYAK WATER TEST! (WITH SUPRISE CATCHES)
HOW TO REMOVE CAN AM OUTLANDER 850XT FRONT PROP DRIVE SHAFT BOOT
Просмотров 1364 месяца назад
HOW TO REMOVE CAN AM OUTLANDER 850XT FRONT PROP DRIVE SHAFT BOOT
SPIRAL FISHING GUIDES EXPLAINED. (WHY USE THEM & HOW THEY WORK)
Просмотров 2,2 тыс.5 месяцев назад
SPIRAL FISHING GUIDES EXPLAINED. (WHY USE THEM & HOW THEY WORK)
FLORIDA SNOOK FISHING WITH INSANE BLOW UPS! (CATCH CLEAN & COOK)
Просмотров 2538 месяцев назад
FLORIDA SNOOK FISHING WITH INSANE BLOW UPS! (CATCH CLEAN & COOK)
HUNTING THE GEORGIA RUT 2023 (McRae, GA)
Просмотров 11 тыс.9 месяцев назад
HUNTING THE GEORGIA RUT 2023 (McRae, GA)
HOW TO PROCESS YOUR OWN VENISON (CARIBOU MEAT)
Просмотров 27711 месяцев назад
HOW TO PROCESS YOUR OWN VENISON (CARIBOU MEAT)
INSANE SOLO ALASKAN CARIBOU HUNT (MUST WATCH)
Просмотров 2,6 тыс.Год назад
INSANE SOLO ALASKAN CARIBOU HUNT (MUST WATCH)
HOW TO DIPNET FOR SALMON IN ALASKA (CATCH CLEAN & COOK)
Просмотров 132Год назад
HOW TO DIPNET FOR SALMON IN ALASKA (CATCH CLEAN & COOK)
CUSTOM ASCEND 12T KAYAK WATER TEST! AND GARMIN 9SV FISH FINDER REVIEW
Просмотров 1,6 тыс.Год назад
CUSTOM ASCEND 12T KAYAK WATER TEST! AND GARMIN 9SV FISH FINDER REVIEW
HOW TO REPLACE REAR CV AXLES ON A 2020 CAN-AM OUTLANDER 850XT
Просмотров 5 тыс.Год назад
HOW TO REPLACE REAR CV AXLES ON A 2020 CAN-AM OUTLANDER 850XT
ABSOLUTE HALIBUT SLAY FEST (VALDEZ, AK)
Просмотров 109Год назад
ABSOLUTE HALIBUT SLAY FEST (VALDEZ, AK)
HOW TO PROPERLY BREAK IN A CAN AM OUTLANDER 850XT
Просмотров 1,1 тыс.Год назад
HOW TO PROPERLY BREAK IN A CAN AM OUTLANDER 850XT
SPRING TIME ARCTIC GRAYLING FISHING IN ALASKA!
Просмотров 136Год назад
SPRING TIME ARCTIC GRAYLING FISHING IN ALASKA!
THE FIRST EVER! Ascend 12T kayak with a Motorguide trolling motor!
Просмотров 5 тыс.Год назад
THE FIRST EVER! Ascend 12T kayak with a Motorguide trolling motor!
HUNTING THE GEORGIA RUT 2022 DURING HURRICANE NICOLE.(McRae, GA)
Просмотров 8 тыс.Год назад
HUNTING THE GEORGIA RUT 2022 DURING HURRICANE NICOLE.(McRae, GA)
FIRST EVER CARIBOU! FROM GRINDER TO GRIDDLE THE WHOLE PROCESS! MUST WATCH!! (Hunting Alaska)
Просмотров 501Год назад
FIRST EVER CARIBOU! FROM GRINDER TO GRIDDLE THE WHOLE PROCESS! MUST WATCH!! (Hunting Alaska)
NON STOP ACTION! FLORIDA FISHING MASHUP (SNAPPER, COBIA, BASS, AND MUCH MORE!)
Просмотров 9292 года назад
NON STOP ACTION! FLORIDA FISHING MASHUP (SNAPPER, COBIA, BASS, AND MUCH MORE!)
GETTING WORKED BY GIANTS (FISHING PANAMA CITY,FL)
Просмотров 3332 года назад
GETTING WORKED BY GIANTS (FISHING PANAMA CITY,FL)
BATTLING GIANTS FROM A 10FT KAYAK PANAMA CITY BEACH FISHING
Просмотров 3632 года назад
BATTLING GIANTS FROM A 10FT KAYAK PANAMA CITY BEACH FISHING
CRAPPIE CATCH, CLEAN, AND COOK WITH 2 SURPRISE CATCHES! (feat. Aaron Royster from red.oak.outdoors)
Просмотров 3522 года назад
CRAPPIE CATCH, CLEAN, AND COOK WITH 2 SURPRISE CATCHES! (feat. Aaron Royster from red.oak.outdoors)
ASCEND 12T KAYAK REVIEW AND MODIFICATIONS.
Просмотров 11 тыс.2 года назад
ASCEND 12T KAYAK REVIEW AND MODIFICATIONS.
I'm going back and watching through all your hunting vids! its very entertaining and getting me ready for this season. Hope you make more this year <3
Thank you I really appreciate that! And oh yeah I’m working on my recent caribou hunt rn.
What caliber rifle is that
7 rem mag
What camo brand is this
Kilik
Nice video man
Can you put two people in that kayak???
My wife and I both fit in it and I could stand up fine.
What size is that swing arm nut? Thanks
No hunters orange requirements??
I always wear my orange, but if you read my previous comment you’ll see why I had to take it off
Hey question, Headed to Valdez for a couple weeks. Any place I could peddle to on my kayak and get on some fish? Maybe rockfish, halibut?? 👊🏽 Anything helps 🇺🇸
Honestly I’ve never kayak fished in Valdez, but there’s places in the bay to catch halibut and rockfish, just stick close to the mountains
@@inthemeat4841 Thank you very much!! Really appreciate it!
Nice hunting ...Nice hunts....do me a favor, I know in the heat of the moment, things happen...but, please get you some ear plugs. I have a few pair. I mainly like the string connected ones, that way , I can let one just hang down until I get action in my area. Gotta try to save that hearing as much as possible. Good shooting.....
They in fact was in the meat
You guys suck. You're not fisherman you're Drunk ass holes.
So says the drunk ass hole. LOL
Best video ever
Samon shark
Northern Pike
Fish of some sort
Muskegon
Nice review. Going to buy this kayak used need seat mod
Was the xi3 not working well on the 12t? I was thinking about doing the same rig on my 12t.
It works amazing I just wanted to get a bigger yak
Don’t tease me like that 😉
what did you use to cap off the access hole?
A phone mount 😂
What to watch for before you get it: Bought one Sat at Cabela's...$527 with discounts, Tuesday deal, Club Member, etc. Was watching another U Tube video Sat night and realized I had the same problem. If you buy one, not online and shipped, check to see if the scuppers below the seat are flat, not with a molehill slope up to the hole. It is hard to tell but when I had it flat and poured a pitcher of water in the seat well area the water would not drain fully. There is a molded in crease/slope several inches behind the scuppers going across the seat area width and that is ok. The raised scuppers below the seat is a defect that sometimes/oftentimes occurs when they release it from the mold. It should feel flat like the aft compartment scuppers. I took it back on Sun to Cabela's and they swapped it out no problem, just a little paperwork at customer service. For some reason they said they owed me $14.xx so they paid me that which made it roughly $513. Now, will spend a few hundred more on a paddle, anchor trolly, and raise the seat, etc. lol Also, the screws for the handles and bungee hold downs need backed off and clear silicone applied or water will leak in.
😯
Sick set up. What trolling motor?
Motor guide Xi3 55lb thrust 36” shaft
Dude I’ve been eyeing one of those yaks for a while now!
Hi, i have same kayak. Does it way the front down or is it good?
It’s good man, but the ascend 133x isn’t that strong up front, I’m gonna add some kind of support through the yak to make it more sturdy.
@inthemeat4841 ok..I thought you put it on the 12t? Or wad is the 133
@corefishing4858 I put it on both, I sold the 12, but yeah that thing was a beast with the motor, no issues at all, if you can afford a lithium then def get one
You’re such a beast! 🔥🔥🔥
Any grouse hunting tips for a newbie in se ak?
lol well, first dig in the regs for your GMU, and grouse hunting it’s super easy, they like standing in a road or trail and are easily startled, I used a 12Ga last year but I might switch to a .22
In with the new! 🍻
Picking one up in the next couple days... excited to say the least! Checking out all the yak fishing upgrades!!
Hope you enjoy it!
DONT CONFUSE ME AGAIN ITS NOT FUNNY ANYMORE
Everyone is always using this bob marly song it’s getting played to much pick another one
how you ride with your shocks on the min setting? crank them up
It’s 3rd setting from bottom. Pretty sure that’s the stock setting from factory. If you do mostly touring riding like I do, it’s not bad.
Yüzme dersi almış 😂
ROTAX quality
You get a machinist BILL. Have more respect for your machine....
Where is the beef 🤣🤣🤣
Did you let your GF drive it or what?😢
I feel bad for you
Eck lake?
Yes 2:53
After some time with your Xi3, what are your thoughts on it? Has is held up to your expectations or has some time and experience with it over time proved otherwise? I'm thinking of getting an Xi3 for my own Ascend 12T, but have seen mixed reviews in regards to the remote not working as advertised. Additionally, have you used the Xi3 in any type of salt water? I plan to be able to fish in both fresh water and brackish water. They have a saltwater version of the Xi3, but figured I'd see how the freshwater holds up before spending the extra cash on the saltwater version. Thanks!
Honestly I haven’t had any issues with it whatsoever. I haven’t had the chance to bring it to salt water but I’m sure it’ll be just fine.
@@inthemeat4841 Awesome, thanks for letting me know!
@@inthemeat4841 hey man, getting ready to install my Xi3 on my Ascend 12T. When mounting the lower plate of the quick mount, how did you position it over the indent for the front handle? I removed the handle itself but it looks like two of the bolts will partially go through the curved surface of the indent. Any tips or tricks?
@jakefedorczyk5674 yeah I was worried about that too, make sure you back the plate up as far as it’ll go, but also have the motor on the mount to make sure it fully engages and locks when you put it down. Once you find the sweet spot don’t let the plate move, mark the holes and drill it
The swing arm nut how tight was it because I have everything off besides that and my 1/2 inch impact will not break it free
Yeah it was a pain, try it by hand with a wrench or ratchet
When you are building a spiral guide rod and you spine your blank before setting your tip top do you set it spine up or spine down for conventional reel. For spinning reel?
Spine down or whatever the factory curve is, these glass rods aren’t perfectly straight lol.
Thanks for this video great ideas
My grandfather used to make his rods like this in the early 80s.
I just picked up a 12t off of offer up basically brand new.. thinking of using your same mods myself.. they look easy and transparent!
You’ll really like the trolling motor mod then🤘🏽🤘🏽
The primary aim of spiral guides is to eliminate sides roll fatigue, whereas line touching the blank are secondary. It's more obvious in big game fishing.
avoiding line tip wrapping in spj also
@@user-wg9du5si1o Yes, I forgot about that.
All my Salmon rods are spiral wrapped on NFC blanks, so good!
Are you in AK?
Nope, lower Columbia River.
@@skamok7I’m in lower Columbia also. Waiting for my blank to come in to try this on.
What blank did you get?@@elevatedangling1973
First comment 🎉
But did you subscribe is the real question 😂
I have been for a very long time
@@inthemeat4841and I have notifications 🔔 🎉
Well in that case, I appreciate it 🤘🏽
Np
Get home let’s gooo
I just got onto a lease in that same area. Been told rut is 1-2nd weekend if November.
I’ve been hunting the same part of GA for 22 years, and I can agree that, that is a true statement.