Видео

Thank you for watching. The machine in the video had its reservoir removed while it was brewing which caused the failure.

A 10 year powertrain warranty would also be very confidence inspiring 😂

In the video I install a Bosch 3323 oil filter from Rock auto, they are a great place to buy car parts from. I recommend googling around for a 5% discount code.

The plate lights are wired to the parking light circuit(the dim rear brake and front orange and white lights that are always on when parking or headlights are switched on). Have you tried changing the bulbs? I would be surprised if all your parking lights worked but both plate lights had wiring problems.

@@welfarewagonrepairs yes i have change bulb to LED, i now know the problem. LED is not contacting well to the socket

You can turn on all the electrical loads like high beams, lights, fan, and see if the voltage drops below the range shown in the factory service manual

@@welfarewagonrepairs Yes but I was wanting to see the actual voltage on the screen like 13,8 Volts or 12.8 Volts etc

Voltage is shown at 8:14 in the video within the graph

Thank you for watching!

Oil viscosity is likely chosen to meet fuel economy goals and takes into account the weather of the North American market. There’s a lot of discussion around oil viscosity and the different recommendations in different markets on Mirageforum.com I personally do not think that high ambient temperature will have a big impact on the recommend oil viscosity as the operating temperature of the engine is always much higher than ambient. I personally only use the oil viscosity recommended by the owners manual as I would like to keep my warranty valid. Thank you for watching!

Glad I could help, Thanks for watching!

They are from the factory service manual. You can find one by searching for it on mirageforum.com

Glad you found the video helpful. Thank you for taking the time to leave this comment.

I recommend tightening the nuts while the car is in the air as the weight of the car may prevent the nuts from tightening

I appreciate the kind words. According to Mitsubishi’s US website the floor lighting is 152 USD, the Center console lighting is 84 USD. Unfortunately I cannot spend 200+ dollars to make a RUclips video. I do not earn any income from RUclips. I recommend leaving any installation questions you have on mirageforum.com Thank you for watching!

I am left handed which makes it much easier as there’s a radiator hose in the way if you try to use your right hand.

@@welfarewagonrepairs I managed to get mine attached from the top today!!! Lol. It's impossible to do it from underneath. You can't see what you're doing!!! Great videos!!!

@@jeffj6815 my Mirage is missing the black plastic piece on the bottom which makes replacing the filter from the bottom easy. Thanks for watching!

Only changing the radiator and reservoir fluid is definitely an option. Within the video I show how much fluid comes out of the engine drain plug to give you an idea of how much fluid you will be leaving within the engine.

I am delighted to hear you found the video helpful. Thank you for watching!

Yes the arrow should be pointing down and the side with the larger surface area will be pointing up so there is more room to catch the dirty outside air that is sucked from above the filter down into the blower motor. This is discussed at 5:55 in the video.

Which opening?

Glad to hear you enjoyed the video. Thank you for the kind words!

Glad to hear the video helped you fix your Keurig. Thank you for watching!

I listed to the song and agree it would be appropriate 😂. Unfortunately it does not appear to be royalty free, RUclips would likely give me a copyright strike if I used the song. Thank you for watching!

Glad you found the video helpful. Thank you for watching!

Glad to hear you are enjoying your Mitsubishi Mirage. Thanks for watching!

Glad you found the video helpful! Thanks for watching!

Thank you for watching!

Glad to hear it went well! Thank you for watching!

Thank you for watching!

There are also automatically resetting fuses available. It’s likely setup like this to force users to disassemble and inspect the machine before resetting it. It’s also causes the machine to fail when the user does something inappropriate. For this particular machine the water reservoir was removed making the user feel at fault for its failure and more likely to replace it. If the reset button was accessible people could also try and leave something in the hole disabling the fuse. Thank you for watching!

I did not reset the degradation level. I am not sure if there is a benefit in doing so.

Thank you for watching and taking the time to leave this comment!

I have a video reviewing the blue driver obd2 scanner where I show some of the live data available. Do you currently have a check engine light/trouble code? What made you want to check the O2 sensor voltage? If you search on mirageforum.com you can find a factory service manual which might tell you what the appropriate voltage/diagnostic steps are

I installed it where the factory one would go if I had the higher trim with the touch screen radio. It’s all plastic above it. GPS quality is not good. Using Waze the gps works much better but the phone also gets warm. I think they are using the phones gps in combination with the radio. Newer cars will use the can bus data for speed and steering position to help with gps. An aftermarket radio can never compete. The radio gps works fine as long as I don’t drive downtown. I would compare it to maybe a Samsung s4 from a decade ago.

Thank you for watching!

5.9 newton meters it’s shown in the diagram at 9:57 in the video. It is not very tight. I was very scared of stripping the bolts as there is very little thread. Your problem is likely that the pan is either warped or that some sort of dirt is trapped between the pan and the transmission. My car didn’t even come with a gasket.

@@welfarewagonrepairs interesting, I also applied 5.9Nm and in the order it asked for. I’ll give it a clean and check the pan is straight. Thank you

In this specific instance the water reservoir was removed while the unit was running.

If they all break It will still work and look half decent as it’s really just the black piece behind the water reservoir that is necessary to hold the outer housing to the machine.

What kind of issues are you having? Does the brush spin if you force it with your hand? The other end of the brush has a removable cap and bearing you can pull out clean and try and grease. You can also trick the vacuum into starting by covering the 4 drop sensors with your hand or tape to make it think it’s on the ground. They do sell replacement roller brush motors on the eufy site

You could also try and start it without the brush installed to see if it spins.

@@welfarewagonrepairs I found the roller brush was not rotating as it got tangled with hair and the square edge of roller brush which connects to the motors spinner is worn out (possible roller brush was stuck but spinner was strong enough that caused the square edge to smoothen out) thanks for the informative video on how to dismantle the robot and identity the issues much appreciated sir.

@@09Abhinandan that is a common problem, you can find them for sale on Amazon and AliExpress. Thank you for watching!

Yes. But your discs and drums maybe larger than mine and your drums may use a different style of auto adjuster than shown in the video. I think in Canada 2017 and newer get the larger brakes. You can see photos of the differences on mirageforum.com

Yeah I think its a reliable vehicle but I would not buy one new today unless you are getting a good deal on it. There are rumors that the vehicle will be discontinued next year which would lower its value. It's also not a great value in todays market. You need the top trim (GT) to get basic collision avoidance in Canada. No Mirage offers the basic features that come with a Toyota Corolla such as: more than double the horse power, rear disc brakes with an electronic parking brake, telescoping steering wheel, heated windshield wipers, Blind spot monitoring, rear cross traffic alert, lane trace assist, radar cruse control, wireless CarPlay, independent rear suspension, GPS tracking. Not to mention higher trim Corollas features (heated steering wheel, remote start, nicer seats, All wheel drive, sun roof, phone charger, available hybrid system, better sound system, better fuel economy with active grill shutter). The LE trim corolla in canada is 27k MSRP. The top trim Mirage in white is 22k. If I was in the market for a new car I would definitely get the Corolla LE trim or higher. I tried the radar cruse with lane tracing assist in a Corolla before and it is life changing.

Thank you for watching!

Great tip, Thank you for watching!

Yeah, there is a solenoid in the shifter. It’s called a shift interlock solenoid. It actuates whenever you press the brake pedal while in park. If the car is in park it will prevent you from shifting (e.g knee hitting shifter) without first pressing the brake pedal. If you look closely at the shifter there is a small plastic square that can be removed to allow you to bypass the solenoid. You would do this if it jams or if the car battery dies and you need to shift into neutral. (On other cars some people remove this bypass to make the car harder to steal via towing)

@@welfarewagonrepairs your the best buddy! Thanks for all the info much appreciated!

@@Gunner-qz9sh always happy to help, thank you for watching!

Yeah, automatic/self resetting fuses also exist. It’s probably like this to both encourage you to throw the machine out and to force you to inspect the inside of the machine before resetting it. If you search online you can see photos where by the time the thermal fuse blows some of the machines internals have already melted.

Thank you for watching!

no se necesita silicona. Originalmente no había nada, ni silicona ni junta. Agregué una junta. Gracias por ver!

@@welfarewagonrepairs gracias por responder, saludos

I have never seen an after market drain plug for this car before. I am not sure doorman makes one. It’s possible that it will only leak when the engine and coolant are warm as the radiator is under pressure, it’s also of course possible that it will leak all the time. Have you checked if the washer on the plug is damaged?

Thank you for watching!

Thank you for watching!

Thank you for the kind words. Jacking the car up is not necessary because if you look at a photo of the radiator online you can see that the top of the radiator is already sloped towards the cap so that air will escape with the car on level ground.

Is the “door open” light on the dashboard also on? Have you tried using a screwdriver as shown at the two minute mark in the video to test if the switch in the latch works?

Yes sir, all 6th generation mirages 2012-2024 are very similar. If you have auto start/stop (not available in North America) then you will have an electric cvt fluid pump you may need to remove to access the side filter