Im building with nearly the same parts I ordered from Houston rc and I'm having a small issue with interference from the very small screws installed on the first step on the lower arms interfering with the chassis. I think I'm going to leave then partially unscrewed for now, but I don't know what their purpose is
If you are referring to the M1.2x3 PB screws, they are for adjusting droop. Make sure they are not screwed in all the way. The proper way to adjust this setting is to use a droop blocks and gauge. I think at the end of the manual it shows you can eyeball the droop by screwing them down so that the lower arms don't fall past level.
Im building with nearly the same parts I ordered from Houston rc and I'm having a small issue with interference from the very small screws installed on the first step on the lower arms interfering with the chassis. I think I'm going to leave then partially unscrewed for now, but I don't know what their purpose is
If you are referring to the M1.2x3 PB screws, they are for adjusting droop. Make sure they are not screwed in all the way. The proper way to adjust this setting is to use a droop blocks and gauge. I think at the end of the manual it shows you can eyeball the droop by screwing them down so that the lower arms don't fall past level.
@ thank you I was able to figure this out