Thanks for the review, especially the honesty that it wasn't perfect for you. I use this to improve the product. Side notes: 1. The X cable wire length between the controller and first limit is setup so that it matches up with the module cable and enters the gantry through the same notch. I'll update the instructions to make that a bit more clear. 2. The number of included cable clips is so that some can be used along the inside of the gantry. Your use zip ties also works too of course. 3. Next product update will have sleeved cables and have epoxy to keep the wiring intact at each connector. 4. For those that need them, longer screws for the right X limit (the one at the flame sensor) are also included. A small number of folks received machines with screws which were shorter than the machines I received, so longer versions were added to the kit just in case Thanks again!
Hello, I just finished the installation of the limit switch by geeks at large and it showed the "home successful" message; home is front left. I tried to "frame" and it moves quickly to the right and it shows the "hard limit confirm" message and it doesn't move from that position. Would you know how to fix this? thank you.
@@3DPUK-TECH-CHANNEL I think I found the problem. Apparently the "start from" was still under origin and I just changed it to "absolute coordinates" and it did frame, finally after a week...
Thanks for the review, especially the honesty that it wasn't perfect for you. I use this to improve the product.
Side notes:
1. The X cable wire length between the controller and first limit is setup so that it matches up with the module cable and enters the gantry through the same notch. I'll update the instructions to make that a bit more clear.
2. The number of included cable clips is so that some can be used along the inside of the gantry. Your use zip ties also works too of course.
3. Next product update will have sleeved cables and have epoxy to keep the wiring intact at each connector.
4. For those that need them, longer screws for the right X limit (the one at the flame sensor) are also included. A small number of folks received machines with screws which were shorter than the machines I received, so longer versions were added to the kit just in case
Thanks again!
Appreciate the comments, to be fair I can be sausage fingered so could be me too.
Hello, I just finished the installation of the limit switch by geeks at large and it showed the "home successful" message; home is front left. I tried to "frame" and it moves quickly to the right and it shows the "hard limit confirm" message and it doesn't move from that position. Would you know how to fix this? thank you.
Are you using lightburn?
@@3DPUK-TECH-CHANNEL yes, and I followed the instructions
@dhurata6235 that's really odd I'm away on business this weekend so next work i will check all my settings as I'm sure I had some issues too
@@3DPUK-TECH-CHANNEL ok, thank you. Appreciate the help
@@3DPUK-TECH-CHANNEL I think I found the problem. Apparently the "start from" was still under origin and I just changed it to "absolute coordinates" and it did frame, finally after a week...
Is there a way to turn on the air asset automatically?
@@fredrick_leicht unfortunately not
@@3DPUK-TECH-CHANNEL That is a shame. That is the one thing I keep forgetting to turn on.