Not sure. You can probably find one. It might be integrated into the throttle body or below it. My error went away by cleaning the intake and throttle body
Those intake manifold back off all the time and cause huge air gaps that leads to messed up fuel injectors and all kinds of codes I just went through hell diagnosing mine and fixing it I bought plugs and coil packs that wasn’t the issue but at least those are done I kept getting a misfire code so I replaced a fuel injector and the gasket on the intake manifold and torqued do be aware that there is a sequence to tighten the bolts I added a little blue locktite to the screws and torqued to 11 lbs it’s 6 bolts holding that manifold on 1 you have to get to underneath the car and 5 across the top once I did all that and plugged all the harnesses in my car is running good again it’s been a few days no issues
Me sorprende la manera en la que manipulas la marposa de el cuermo de aceleracion Ya q es un error Lo mas seguro esque terminaste descalibrando el cuerpo de aceleracion En ningun momento la deven de manupuelas asi ni conectada ni deconectada
Changed the map sensor 3x this month. Code goes away and comes back days later. Car stalls sometimes and wont start back up right away
@KyondusMosley maybe try MAF sensor or at least clean it. Did you clean the throttle body?
did you figure this out? You might also want to tighten the intake manifold bolts.
Where the video to change senser
Not sure. You can probably find one. It might be integrated into the throttle body or below it. My error went away by cleaning the intake and throttle body
Those intake manifold back off all the time and cause huge air gaps that leads to messed up fuel injectors and all kinds of codes I just went through hell diagnosing mine and fixing it I bought plugs and coil packs that wasn’t the issue but at least those are done I kept getting a misfire code so I replaced a fuel injector and the gasket on the intake manifold and torqued do be aware that there is a sequence to tighten the bolts I added a little blue locktite to the screws and torqued to 11 lbs it’s 6 bolts holding that manifold on 1 you have to get to underneath the car and 5 across the top once I did all that and plugged all the harnesses in my car is running good again it’s been a few days no issues
@b3atzbyoh10 glad it's fixed. That is one long sentence for sure!
@ lol I know but these malibus are a headache it can be 4-5 different things for one code and when you get multiple codes it becomes a short story😂
Como se llama esa pieza
The silver circle on the right is the throttle body. The long plastic dark piece is the intake manifold
Me sorprende la manera en la que manipulas la marposa de el cuermo de aceleracion
Ya q es un error
Lo mas seguro esque terminaste descalibrando el cuerpo de aceleracion
En ningun momento la deven de manupuelas asi ni conectada ni deconectada
It didn't translate this for me.
so far so good. no issues with cleaning the throttle plate.
Did it run better after this??
Not really that I noticed but the code went away