I cant get mine to run below half slow. Gets to the o in slow speed then dies, the only thing i can think of is if the throttle linkage is not set right . Also i have no idea how to tell which model td it is .. my handle and pull cord are the only thing different from yours
@@michaeljsimon when you say "bad" does that mean it is not pulling the rod up to shut off gas flow? The cork is positioned on the rod with a brass pin that goes around the rod....how high up do I put the cork on the rod?
![KSI - Dirty [Official Visualiser]](http://i.ytimg.com/vi/VoDh1h1dPUE/mqdefault.jpg)
Your the best Mr t mike I appreciate the knowledge you have been given me in all your videos and you are a great mentor
I cant get mine to run below half slow. Gets to the o in slow speed then dies, the only thing i can think of is if the throttle linkage is not set right . Also i have no idea how to tell which model td it is .. my handle and pull cord are the only thing different from yours
TD number is stamped on powerhead
Is this the same way to dial it in for a HD25, because I’ve tried this and having a real hard time getting it to work
Yes
Hi Mike I have a 41 johnson 2.5hp same carb setup.... I have gas coming out of the top of my carburerator....any help with that?
Yes. Your carb has a float inside tied to a rod that seats when full to stop fuel flow. Either your float is bad or rod is not seating.
@@michaeljsimon when you say "bad" does that mean it is not pulling the rod up to shut off gas flow? The cork is positioned on the rod with a brass pin that goes around the rod....how high up do I put the cork on the rod?
Can I take it apart and send pictures?
and how far can you go sliding the throttle to slow before it konks out?
Half way to stop.