Just found your videos. I just picked up the pro second hand from voxelab directly and i like it! but, Why didn't they just base it off the x2 i haven't a damn clue. That probe is a huge pain!! I'm like you i seen that prompt to calibrate after the update and just clicked away from it and then it about snapped it off on the bed clips while doing a z-offset. They mention no where about going into the level feature and tapping 5 times next to the back portion of the screen to go back into the calibration feature.. I have only had it for a few days and haven't printed anything but a calibration cube. but, It does seem to print pretty well. Mine to may become a franken printer if it acts up.
any chance of a tutorial on this? I'd like to change my mainboard and firmware as im struggling with voxelabs. Also do you think I could put a direct drive on this thing?
Just found your videos. I just picked up the pro second hand from voxelab directly and i like it! but, Why didn't they just base it off the x2 i haven't a damn clue. That probe is a huge pain!! I'm like you i seen that prompt to calibrate after the update and just clicked away from it and then it about snapped it off on the bed clips while doing a z-offset. They mention no where about going into the level feature and tapping 5 times next to the back portion of the screen to go back into the calibration feature.. I have only had it for a few days and haven't printed anything but a calibration cube. but, It does seem to print pretty well. Mine to may become a franken printer if it acts up.
Yeah, I was disappointed in the information they provided, or should I say lack of information.
any chance of a tutorial on this? I'd like to change my mainboard and firmware as im struggling with voxelabs. Also do you think I could put a direct drive on this thing?
I'll try to make time for a tutorial some day, good idea.
@@3dprintablesllc271Waiting for your tutorial too :) I want a stable connection via WiFi and full control ...