Assembling pistons and rods for a Mazdaspeed
HTML-код
- Опубликовано: 25 авг 2024
- This is a video on how to assemble pistons to connecting rods.
I realize everyone probably has their own method and their own opinion but this is how I do it and this method has been very successful over the years.
Please check out and like our Facebook page!!!
/ oddballindustries
Category
People & Blogs
My pins don’t fit my rod small end bore. Any advice?
If I change the rods (one had a spun bearing) on my 2.3L Mazda Turbo with these rods, would the crankshaft need re-balancing at a machine shop or are they OEM weighted?
How did they work for you?
so I have the manley platinum pistons 22.5 mm wrist pin on their way, but struggling to find manley h-beam rods everybody out of stock. Thinking of molnar h-beam rods. would we have any problem with these rods?
Dudeee what's the sone in your intro??
I'm currently building a spare engine for my ms3 I have manly h tuff beams and platinum pistons and a stage 3 rebuild kit from edge autosport I can decide what bearings to use. I'm just doing a mild build. I want a bullet proof bottom end and daily reliability. I'm not shooting for anything crazy just full bolt ons and a bnr s2/3 turbo . So what bearings would you recommend or have the best of luck with
Manley 87.5 pistons? Gapped at 0.020 top and 0.024 second ring?
I am curious as to what rod bearings you’re using. I have the OEM press fit and they would spin freely if I tried to install them. The engine builder that’s helping me said that Manley rods use a tanged rod bearing instead of OEM.
Did you figure this out?
You use king racing bearings
Very helpful thank you, I was looking to replace some pistons in my Mazdaspeed3 (2007) and I was looking at the Manley Platinum Series, any opinions on that?
Jack Powell I loooooove Manley platinum series Pistons, on my engine that's what I used to make over 600hp
Are the pistons good for a daily that is just gona be rebuilt?
Do Manley rods have markings to distinguish the thrust side when assembling them into to block?
MrStoneycool69 it depends engine to engine because not all rods are the same obviously but if we’re speaking purely mazdaspeed 4 cylinder there is not a mark on the rod. I always put the manly etching facing the front of the engine, if you have a V engine you’re going to want the big chamfers to face the cheek of the crankshaft, i hope that helps, if you’re still having trouble message me on our Facebook page and I’ll try to help you more!
Okay, thanks for the reply.
What’s the absolute MAX horsepower a stock MZR mazdaspeed engine can withstand before running into engine problems?
Alyn Romero 7
Sucks he never did the video on how to cut the rings
Why do you hate Wiseco pistons? Are they not manufactured properly ??
mikef058 there is nothing wrong with them technically. I feel like they made a cookie cutter pistons. As in they took their original run of the mill piston and just made it to the size of the mazdaspeed bore. Also they have SUPER short skirts so that’s where the piston slap comes from when they are cold. And the other reasons I mention in the video
Why do pistons matter for a 4 cyl vs a v8? Lmao