I came here for the same question. I do believe it's made like that so the bit does not over tighten and is hard to get back off. I think that's the only reason for it. Personally I'd rather not use it and have a tight fit if precision was needed. If not then a slightly sloppier of a hole is an alright trade off for easier accessibility (That's what she said)
I follow those instructions and the saw fits very loosely on the shaft -- it rattles around on it. How is this a good thing?
I came here for the same question. I do believe it's made like that so the bit does not over tighten and is hard to get back off. I think that's the only reason for it. Personally I'd rather not use it and have a tight fit if precision was needed. If not then a slightly sloppier of a hole is an alright trade off for easier accessibility (That's what she said)
في علا مقاس دائره 20×20
Cer. Brpa duwit. Bang
Алюминий... Где металл
Cer. Brpa duwit. Bang