Infinity Mega Flush Trim Router Bit Demo with Useful Tips for large diameter flush trimming bits
HTML-код
- Опубликовано: 6 сен 2022
- Demonstration of the Mega Flush Trim router bits from Infinity Tools including tips and techniques for smooth, flawless template routing. Even with changing direction these Mega Flush trim and Mini Mega Flush Trim bits yield smooth performance.
Infinity 06-695 Mega Flush Trim Bit... amzn.to/3qjevlg
Infinity Mega Flush Trim Kit... amzn.to/3x1qtDI
Infinity Mini Mega Kit... amzn.to/3evi2KB
Or shop my entire curated collection (Shop Tested) on The Thoughtful Woodworker Storefront…
www.amazon.com/shop/thethough...
As an Amazon Associate I earn commissions, and am grateful for your support.
#woodworking
That is a great bit. I've used it to cut guitar fretboards out of rosewood and ebony. Cuts super smooth. Nice video. And yes, the nature of the shavings is incredible, especially off mahogany.
Will this substantially reduce kickback? I have a very high quality up down but the the kick back was incredibly scary.
I bought one of these bits. It was the 2 " tall 1 1/2 inch wide one. It was extremely loud and had a fair amount of vibration. I used it in a router table with large router motor at 16,000 rpm. Over the course of 5 min the vibration caused my router lift to raise up by 1/4 inch. It is a JessEm lift and works very well with all other bits I have used. Is this normal for this bit to be so loud and vibrate so much? It seems unsafe and the cut quality was not as smooth as your video suggested is should be.
How would you compare infinity versus white side router bits just interested in your opinion?
How would you handle material that is taller than the router bit? Let's say the material was 3 inches tall. Would you take multiple passes -- i.e., remove the top bearing, take the first pass to remove material, raise the bit and remove the remaining material? I am asking because this is what I am dealing with and not sure how to go about it. Would really appreciate your guidance. Thank you.
Hi, do you think this will run good with 10000 rpm ? My router has an max. Speed of 10 k.
How much cost one piece bit in india
If Infinity could make one for a shaper with 3/4" or 1" Spindle they couldent make them fast enough as they would go of the shelf as there was no tomorrow!!!!