While prying out the emblem, do note not to wiggle your Pryer left and right as it might deface the surface paintwork. Just pry it upward at different points.
The link attached only has the bmw 2 pin badges not the stick on ones that are required for the front. Are you bringing back the black and white stick on ones?
Everyone who watches this might want to be aware that I just replaced the badges on my e89 Z4 and even though the rear and the sides were stick on like in this video, the one on the front has screws. They are not difficult to get to but I had to remove the filter intake to get to it. One video on RUclips shows removing one of the kidney grils but I'm a pretty small guy with skinny arms so if you're bigger you might have too.
While prying out the emblem, do note not to wiggle your Pryer left and right as it might deface the surface paintwork. Just pry it upward at different points.
Appreciate your effort in showing how to do it especially the rear emblem.
🙏🙏
The link attached only has the bmw 2 pin badges not the stick on ones that are required for the front. Are you bringing back the black and white stick on ones?
So the f20 back badge is the same to take off ?
Yes. The video is for F20 replacement
How did you stop the trunk lifting and shutting ?
If your model has electronic tailgate, then you can temporarily remove the fuse for the tailgate so that it will not lift automatically
Leave key at home 😂
Did you have to disconnect the batter for the trunk?
Not required for such work as seen in the video
How did you stop the trunk from lifting and shutting?
What sizes are they? The trunk and front?
Both using 82mm diameter
How do you do it with the ring around the bmw sign?
The ring does not obstruct the removal as seen in the video.
What are the size of the rear and the front logo please?
Both using 82mm diameter
Nice! Where did you bought them?
the replacement item can be obtained in the link provided in the description.
Could you please tell me where can I find the black ring on the back rear boot? Thanks in advance!
Hi, that’s plasti-dip and not trim.
Everyone who watches this might want to be aware that I just replaced the badges on my e89 Z4 and even though the rear and the sides were stick on like in this video, the one on the front has screws. They are not difficult to get to but I had to remove the filter intake to get to it. One video on RUclips shows removing one of the kidney grils but I'm a pretty small guy with skinny arms so if you're bigger you might have too.
👍 Appreciate your sharing with the community on the replacement on E89 model.
@@swanzee You're welcome, I almost started prying mine off but I chanced upon the screws.
BMW is keeping us on our toes.
This video is meant for BMW 1-Series F20 F21 as indicated in its title. Therefore, it’s not applicable to your Z4 model.
@@swanzee Gotcha..I have one of those too. Lol
Bendede var bmw e87 çok severek biniyorum 🙏
No way it was that easy?😂
I think you could easily use your nails to pry instead of prying tool🤦🏻♀️
Yes, that can be easily done but it’s not a good demonstration as not many ppl have such natural tools.
Bro why ur finger nails so damn long
They are mainly used to pry car out trims without any tools.
@@swanzee you need to cut that shit
@@swanzee why not use a tool
Man that's really ugly 😂😂😂