Glacier Bay Power Flush 2-Piece 1.28 GPF. "10 Easy STEPS To Replace Your Toilet"

Поделиться
HTML-код
  • Опубликовано: 13 окт 2024
  • Ten easy steps to replace or install your toilet. If your toilet gets clogged replace it with a POWER FLUSH👍🏻
    my-store-10694...
    / high_ridge_handyman
    blog.feedspot....
    www.homedepot....

Комментарии • 22

  • @martindurkin5223
    @martindurkin5223 2 месяца назад +1

    The tank just installs itself? Great! I was worried I'd have to figure it out on my own

    • @HighRidgeHandyman
      @HighRidgeHandyman  2 месяца назад

      The toilet does come with instructions on connecting the only two pieces in the box with a couple of nuts and bolts with a rubber gasket in between.

  • @consciousgem229
    @consciousgem229 Год назад +2

    This helped so much!!!! Who would’ve thunk it??
    🙌🏽😁

  • @KathleenMohan-d8j
    @KathleenMohan-d8j Год назад +6

    You didn't show the tank installation - that's what I needed the help with.

    • @HighRidgeHandyman
      @HighRidgeHandyman  Год назад +2

      It’s only two pieces. Put it together and tighten the bolts and nuts. Very basic

    • @antonybateson9060
      @antonybateson9060 9 месяцев назад +1

      I came here for that too ... its 4 soft washers 2 wing nuts and long bolts and two hard washers ... make sure you put the wing nuts under the tank not in ... i hope the hard washers go on the outside too ... ill have to keep lookin to make sure😊 7:56

    • @BReal14
      @BReal14 3 месяца назад +1

      same. i can't get it to seat. it says to push down and turn it side to side until it clicks in to place. I'm on hour 4 of turning it, pushing it, trying again and again and again and it just won't slip in to place. What's the trick?

    • @BReal14
      @BReal14 2 месяца назад

      I eventually got it by wetting the seal on both sides. needed to make a suction. I still don't like the way it seats -- it's a bit wobbly and you can't crank down the clips too tight before it will snap. Cheap stuff is cheap stuff i guess. Flushes well though

  • @johnpalma7265
    @johnpalma7265 9 месяцев назад +1

    If I use a sponge or a shop vac to remove the remaining water in the tank rather than putting a towel on the floor will I run the risk of being deported and/or excomunicated?

  • @alecfrancis628
    @alecfrancis628 Год назад +3

    Erick Morton thinks that the GB Powerflush & the 2000s AS Champion 4/Cadet 3 are the best water saving toilets ever made, because of how they have the best & most OP flushes out of any other non-PA toilet on the market!

  • @206PinoyLife
    @206PinoyLife Год назад +2

    Great installation video! I’m definitely gonna use this when I purchase the same toilet soon.
    Btw, if I don’t have a shop vac, what other method can I use to take out the water from the bowl?

    • @HighRidgeHandyman
      @HighRidgeHandyman  Год назад +1

      Check out my video. How to fix most leaking toilet. There’s a way to remove the toilet with out a shop vac without spilling any water👍🏻 thanks for the nice comment. Good luck Reuben.

    • @owenturley6214
      @owenturley6214 Год назад +1

      A sponge

  • @andrewmartino6144
    @andrewmartino6144 Год назад +2

    "your logs are gone" lol

  • @jaimetorres630
    @jaimetorres630 8 месяцев назад +2

    Damn so the tank just hooked itself up?

    • @HighRidgeHandyman
      @HighRidgeHandyman  8 месяцев назад +1

      Two bolts with the rubber gasket. Put together and send the bolts from the inside out then tighten. Very simple

  • @craiglenhard-rvrguyd
    @craiglenhard-rvrguyd 7 месяцев назад +1

    You missed 4a - - - paint the rear wall.

    • @HighRidgeHandyman
      @HighRidgeHandyman  7 месяцев назад +1

      The old saying the shoe maker walks around with holes in his own shoes😂

  • @djm9583
    @djm9583 8 месяцев назад +1

    You skipped the tank installation.

    • @HighRidgeHandyman
      @HighRidgeHandyman  8 месяцев назад +1

      Two bolts provided with nuts and a rubber gasket put them together tighten them up, pretty basic