Recently installed the Slavens Mule Lectron Billetron carb on my 2019 KTM 250XC. Also installed the S3 high compression cylinder head and SX CDI unit at the same time. The combo is outstanding. Bike pulls harder and smoother from low rpm, which allows me to often stay in a higher gear than previously. I rode it a week ago in 40 degree temps at 4,000 feet, and then 70+ degrees yesterday at same elevation, and the bike ran perfect in both situations. Just want to say thanks to Jeff for putting out these great "Mule" items...my riding has improved, and at the same time I'm having more fun at it!
If someone buys this carb from your shop, are settings that have been proven already in place or are they sold at manufacturers spec and test/tune from there?
I bought mine from Slavens and all I had to do was install it. Was jetted perfectly, and even the idle was correct. Slavens recommendation of installing it and then go out and ride proved accurate. Couldn't be easier.
Glad your priorities are in line! What a great season it has been so far! Thank you for the videos.
Recently installed the Slavens Mule Lectron Billetron carb on my 2019 KTM 250XC. Also installed the S3 high compression cylinder head and SX CDI unit at the same time. The combo is outstanding. Bike pulls harder and smoother from low rpm, which allows me to often stay in a higher gear than previously. I rode it a week ago in 40 degree temps at 4,000 feet, and then 70+ degrees yesterday at same elevation, and the bike ran perfect in both situations. Just want to say thanks to Jeff for putting out these great "Mule" items...my riding has improved, and at the same time I'm having more fun at it!
Thank you. Glad to help.
Kool video is the noticeable fuel consumption
Great content👍🙏🇲🇨💚💗
Sure appreciate your vids Jeff.
At 72 years old I have a bitch of a time getting the cable end back into the slide and the boot back on the carb. LOL.
What are your specs with this carb on that bike ?
If someone buys this carb from your shop, are settings that have been proven already in place or are they sold at manufacturers spec and test/tune from there?
I bought mine from Slavens and all I had to do was install it. Was jetted perfectly, and even the idle was correct. Slavens recommendation of installing it and then go out and ride proved accurate. Couldn't be easier.
All Lectrons we sell have our specs.
@@slaverace1 what different specs do you use?
@@michaelfernie7413 none.
Jeff, do you ever run vent lines up for wet running in your area ?
Yes, it's always good to run two of the vent lines up under the tank.