I have a small HO Train layout using flex track with drop feeders to a bus wire. I have this EZ command station controller. There are two red wires that connect to your track. I don’t have the EZ track. Can I connect it straight to my bus wire? There are two red wire on the controller are both positive?
~I have 6 N-scale running & wanted to know how to get all six on this E-Z Command control center...plz let me know if I bought wrong control. Just have single contols on them now.
Hello sir, thank you for commenting. If you have a DCC ready locomotive that is DC they only run in analog mode. I would upgrade them to DCC. You can buy a decoder and have your local train store install one. Once a DCC decoder is installed you can get more out of the engine. Hope this helps.
@@engineerpat5290 I got a nother? The 2 new logo's are dcc ready on the boxes, don't they already have decoders, I took cover off and found a 8 pin ,I'm guessing it's a decoder
DCC ready is just that. Digitrax has an east to use decoder locator on their website they usually run just under $50. For simple decoders. I think they’re great products
I have a small HO Train layout using flex track with drop feeders to a bus wire. I have this EZ command station controller. There are two red wires that connect to your track. I don’t have the EZ track. Can I connect it straight to my bus wire? There are two red wire on the controller are both positive?
Thank you thank you...yes helped me out alot. Awesome job buddy. You are great 👍
You are very welcome. I am glad the video was helpful! Thank you also for the kind words!
Is there a on and off power # when your not using power pack or do you just pull plug ?
Just pull the plug.
~I have 6 N-scale running & wanted to know how to get all six on this E-Z Command control center...plz let me know if I bought wrong control. Just have single contols on them now.
The N scale DCC locos should have an address of 3. The programming should be the same as I demonstrated in the video.
Coolio…
I like your description…
I just went digital with 5 locomotives
NICE!
hi. do you know how to use the new ez plus command control?
No I do not
Does this ez command controller run Thomas and friends engines?
if they are dcc then yes it should be good!
I got 2 Locos that say dcc ready and I can only run them on analog, with the e-z command what am I doing wrong, I got 3 others that work fine?
Hello sir, thank you for commenting. If you have a DCC ready locomotive that is DC they only run in analog mode. I would upgrade them to DCC. You can buy a decoder and have your local train store install one. Once a DCC decoder is installed you can get more out of the engine. Hope this helps.
@@engineerpat5290 I got a nother? The 2 new logo's are dcc ready on the boxes, don't they already have decoders, I took cover off and found a 8 pin ,I'm guessing it's a decoder
@@geneschindler9537 the DCC decoder that is required is an 8Pin decoder. Digitrax is the brand that I recommend.
DCC ready is just that. Digitrax has an east to use decoder locator on their website they usually run just under $50. For simple decoders. I think they’re great products