The truck had to go in the shop | Loads are Bad ! No money 💰# SFI truck

Поделиться
HTML-код
  • Опубликовано: 16 ноя 2024
  • The truck had a few issues !! I got stopped by Ohio state Trooper and gave me a level 3 Inspection. The Schneider Load board is not looking good .
    Thanks for watching !!
    Music from ( ARTLIST ) subscription.
    1.Milano - Feels

Комментарии • 11

  • @georgewalker6199
    @georgewalker6199 6 месяцев назад +2

    So are you at least grossing at 5,500 a week?

    • @truckingwithjl7826
      @truckingwithjl7826  6 месяцев назад +3

      Yes, once a while I do over five but lately it’s been around 3800 to 4200 gross last week I did 4990 and next week coming. I’ll probably break even because of home time. Thanks for your coming. Be safe out there.

  • @terryb5000
    @terryb5000 7 месяцев назад +2

    It’s not always alignment issue, because my tire was doing the same thing and had the alignment checked and it was fine. Sometimes we can get a bad tire but it’s rare.

    • @truckingwithjl7826
      @truckingwithjl7826  7 месяцев назад

      I thought about that and check the Kng pins things out and they seem to be OK just a little bit of play. I did the alignment. It was slightly off a little bit out I’ll see what happens but yeah it’s some cases some tires they do come kind of defective I did notice that the tire that came with the truck is a different load rating that could have been the issue Also, I put the tire that is on the sticker of the truck..

    • @terryb5000
      @terryb5000 7 месяцев назад

      I have a 2018 Freightliner cascade 125
      I had a bad shimmy in front area and I finally got it taken care of, it needed the drive shaft balance

  • @412hwc
    @412hwc 7 месяцев назад +2

    i spent over 3k chasing an alignment and balance issue. u gon have to shake your drag link off your pittman arm. i had replaced rims tires all that and it ended up just being that.

    • @truckingwithjl7826
      @truckingwithjl7826  7 месяцев назад +1

      Thanks for the advice!! I did have the wrong tire according to the manufacture sticker on the door, I’ll see how the new tire does.

  • @terryb5000
    @terryb5000 7 месяцев назад +2

    You have to do a regeneration on truck after putting Knox sensor on so you might have to let a shop do it

    • @truckingwithjl7826
      @truckingwithjl7826  7 месяцев назад +1

      Yeah, I have automobile scanner programmer. I will see if I could add the Freightliner into it so I could do a Force region after I put the sensor, but if not, I’m looking into the OTR tool.

  • @terryb5000
    @terryb5000 6 месяцев назад +2

    What the heck you doing driver, you making any money this week

    • @truckingwithjl7826
      @truckingwithjl7826  6 месяцев назад

      Everything is good Terry still making some OK money well last week I broke even because I went home but the week before I did 26 and change and this week is looking like 2190 now next week I’m trying to go home again well today is Thursday so I’m trying to be home next Tuesday this Tuesday coming I’ll probably break even again because the fuel but I’m good be safe out there take care