thank you Kev! You always do a good job thoroughly explaining. I bought a few back up blades on amazon just in case the last one that came with the machine goes bad. The blades at plotter depot are just too darn expensive. Also, I notice recently after turning on my plotter that the words on the screen were not showing at all and upon resetting, they would show as scrambled up, dang, I haven't even had the machine for more than 3 full months.
Thank you so much for this video Kevin. I have a Jag plotter on order and have been binging your videos to make sure I get it running well ASAP. Your trick with the 3m Exterior tape layered with Gorilla tape is genius. The part showing a cutout with not enough force, and how to roll the edge of the tint to not waste the pattern is so helpful.
So the plastic cut strip we would normally replace and glue down are you removing that completely and doing the tape? Or putting that back in and adding tape over it?
I ahve a small ploter to do some staff for myself but the vynil is bending when using enought pressure to cut trough, is there any roll tensioner that i can buy to put more on my ploter ?
thank you Kev! You always do a good job thoroughly explaining.
I bought a few back up blades on amazon just in case the last one that came with the machine goes bad. The blades at plotter depot are just too darn expensive. Also, I notice recently after turning on my plotter that the words on the screen were not showing at all and upon resetting, they would show as scrambled up, dang, I haven't even had the machine for more than 3 full months.
Please reach out to customer support. We can send you a new led panel. It's an easy swap.
Thank you so much for this video Kevin. I have a Jag plotter on order and have been binging your videos to make sure I get it running well ASAP. Your trick with the 3m Exterior tape layered with Gorilla tape is genius. The part showing a cutout with not enough force, and how to roll the edge of the tint to not waste the pattern is so helpful.
So the plastic cut strip we would normally replace and glue down are you removing that completely and doing the tape? Or putting that back in and adding tape over it?
I ahve a small ploter to do some staff for myself but the vynil is bending when using enought pressure to cut trough, is there any roll tensioner that i can buy to put more on my ploter ?
Any plans to make set up and or tips/tricks for PPF installers? I deal with bunching up a lot! Especially when cutting larger panels. Thanks.
Workhorse 2 VS TITAN 2? What are your thoughts?
We are trying to communicate with you through the website. I do not know if you received the request or not. Is it possible to get the email?
Loading the film is it clear up or down?
You cut on the tint side so down.
What’s your socials?