Hi Gary, great video. Can you tell me how and where to get a Isuzu 3LA1 Overhaul Gasket Sets for the Injection pump (Zexel 41022). I have a hard time even to find a Zexel distributor. Would be great to get support.
Would it be possible to remove the top section of the pump ie the section retained by the 10mm penta bits without removing the whole pump, i have a leak of diesel and think it may be the o rings Regards Steve
Thank you for your video, when you take out these injector from the engine do you pull them out from the same position it was or you have to turned somehow, I need to extract an injector with a lateral pin on the body like the one in the video that does not come out but I'm able to turn it 90 degrees to the left from its position, thank you in advance for any guideline.
Great video bud.got a question? Do we open these pumps to clean and change o rings? If these pumps are dirty can that make your motor overheat?thank you for the help
Ahh the groove on the element plunger!
by far the best video explanation and tutorial, well done this helped me a lot.
great video mate, very well filmed and explained. Thanks
That was extremely helpful! Thank you.
This is a very good video very helpful for a do it yourself guy , I wish it was for a three cylinder pump.
same here . any idea on how to quantify the ground shims in the roller buckets. mine got mixed up
@@robertmahaney6831 i got a 2cylinder same issue, solved your challenge?
Me too, about to rip into one off a Mitsubishi 3 banger.
@@robertmahaney6831 ha hah... sorry!
very detailed, thanks
Hi Gary, great video. Can you tell me how and where to get a Isuzu 3LA1 Overhaul Gasket Sets for the Injection pump (Zexel 41022). I have a hard time even to find a Zexel distributor. Would be great to get support.
Would it be possible to remove the top section of the pump ie the section retained by the 10mm penta bits without removing the whole pump, i have a leak of diesel and think it may be the o rings
Regards
Steve
Thank you sir!
Thank you for your video, when you take out these injector from the engine do you pull them out from the same position it was or you have to turned somehow, I need to extract an injector with a lateral pin on the body like the one in the video that does not come out but I'm able to turn it 90 degrees to the left from its position, thank you in advance for any guideline.
Excellent video
Hey question … would you happen to know what kind of o rings are required for this injector ?? Any help would be appreciated
Do zexel pumps have oil in them that needs to be changed?
Where did you get your Penta head socket? The only one I can find is 1/2" drive.
You can get the 10mm penta head socket from cta tools
Great video bud.got a question? Do we open these pumps to clean and change o rings? If these pumps are dirty can that make your motor overheat?thank you for the help