Designing of Plastic Products for Injection Moulding - Lecture Wall Thickness

Designing of Plastic Products for Injection Moulding is a course by Prof. Vijay. P. Bapat and Shiv Kumar Verma from IDC IIT Bombay. The proper knowledge of materials and their manufacturing process helps a designer to select the best material as per its application. A good designer always considers the limitations and constraints of the materials in the design phase since materials not only affect the aesthetics of a product but also decide its manufacturing cost. This video explains lecture wall thickness.
For more information visit www.dsource.in/course/designi...
Write to us at [e-mail]

[@rakeshpattanaik7180]

Sir .I salute you .you have cleared my doubts

[@RAHULKUMAR-vm2ol]

Nice information

[@worldofequity...5110]

I will complete mech engg in one month intrested in small plastic moulding cources ..any suggestions

[@amitshahu9248]

Very good info sir...Ek no.

[@rahuldumu5859]

superb sir

[@RoyKrugman]

Wich one better using injection or pressure due air trapped?

[@hyperloop7053]

How do you decide optimal wall thickness of the part?

[@sukheshvsk7399]

Thank you sir.by vetrivel

[@vasanthk325]

Hello Sir,
Could you please add mould size selection video ?
i want to know that how to select mouls size for various component

[@eduardodiosdado9475]

What would happen if instead of injecting from a, you inject from b?

[@worldofequity...5110]

U r sup sir thx

[@muffinman127]

Bro is aerodynamic