Designing of Plastic Products for Injection Moulding - Lecture Snap Fit Less Than 90
HTML-код
- Опубликовано: 20 авг 2024
- A course on Designing of Plastic Products for Injection Moulding was conducted by Prof. Vijay Bapat at IDC, IIT Bombay. The proper knowledge of materials and their manufacturing process helps a designer to select the best material as per its application. A good designer always considers the limitations and constraints of the materials in the design phase since materials not only affect the aesthetics of a product but also decide its manufacturing cost. This clip is about snap-fit less than 90.
For more information visit: www.dsource.in...
Write to us at dsource.in@gmail.com
As usual very insightful sir.
Amazing sir
Salute you
I was expecting cantilever snap joint design and forces using a flexural modulus explanation.
Nice video sir,
Can u solve my one quriery.
How much clearence we'll make with surrounding part. While design a snap?
If possible please make small video on it.
Where can we get the complete lectures. Please let me know
For more information visit: www.dsource.in/course/designing-plastic-products-injection-moulding
max cos is possible if it is 0 degree? am i wrong?
Cos 45 is minimum for both directions, i.e. opening and closing.
i was also thinking the same
What the major name is?
For more information visit
www.dsource.in/course/designin...
Sir can I get your contact no..for any plastic design queries as I m working on automotive interiors plastic
Sir gimme your number I will contact you for any queries!
Where are you working bayya