Permit me ask question, my car is Honda accord 2006 with that code EVAP, I replaced canister but didn’t work, I also don’t see check engine light, in this case the light was removed? I just buy it and was cheated, now can not pass inspection. Thanks
Is this the same for a 2004 Honda element? Is this relay still behind the glove box? I still have a p0135 after I installed a new oem denso air fuel sensor. Thanks.
Not sure about your specific case, but I know that in some cars you can get the light to flash the codes such that you don't need a scanner. I seem to recall doing this before and I think I had to short something to get it to blink the pattern. If that is what is going on - you would need to find the pattern decoder & also check for your car if this is even possible & if something could already be shorted without your prior knowledge.
It would be nice...if the computer could tell you precisely where to look for the problem! No they want you to take it to a mechanic and pay from 300.00 on up! Sucks!
Thank you so much. You saved me from going fully insane after my cat converter got stolen I still got these codes with a new cat and fresh o2 sensors.
What was the problem
Excellent video. I learned some useful tips. Thank you for posting, and I'll check out your other content.
Great video! I'm diagnosing the same fault code and all the research I've done your video is by far the most thorough. Thanks for posting!
Glad it helped
Tip-You check the fuses continuity with your meter without taking them out since they have the contacts on the top.
Great video. Lots of good troubleshooting technique on display - I appreciate it, thanks.
Thanks for these information very helpful.totally relieved my stress.
Really thorough video. Esp describing the wiring diagram aspect. I have the same fault code for the EVAP system. Wish me luck.
Excellent job! Thanks for the step by step diagnosis.
Have a 2004 drivers headlight high beam keeps blowing out. Replaced the electric load detector still same issue
Thanks
Perfect, thank you. Got lucky, my P0498, only code. Connector came off canister valve..
2013 accord lx 2.4l
2013 accord lx 2.4l . P0498 code .. Connector came off the canister valve
2013 accord lx 2.4l... P0498 code cause was connector came off canister valve..
Permit me ask question, my car is Honda accord 2006 with that code EVAP, I replaced canister but didn’t work, I also don’t see check engine light, in this case the light was removed? I just buy it and was cheated, now can not pass inspection. Thanks
excellent ty great video ..man your a smart guy lol
Is this the same for a 2004 Honda element? Is this relay still behind the glove box? I still have a p0135 after I installed a new oem denso air fuel sensor. Thanks.
Any comments why after ignition the check engine light blinks 10 times only and goes off with no scanner code or constant check engine on?great 🎥 👍
Not sure about your specific case, but I know that in some cars you can get the light to flash the codes such that you don't need a scanner. I seem to recall doing this before and I think I had to short something to get it to blink the pattern. If that is what is going on - you would need to find the pattern decoder & also check for your car if this is even possible & if something could already be shorted without your prior knowledge.
🤞🏽 0.20 seconds in ;)
Amigo no me lo creeras pero me diste la solucion mismos codigos crv2013 gracias
Como lo resolviste amigo? tengo los mismo problemas , ppor favor ayudenmeee D:
@@luisfernandotorresrios6365 el rele activa al sensor y a la valvula del canister
Compruebe el rele
@@luisfernandotorresrios6365 en ni caso era el rele q estaba defuectuoso
@@luisfernandotorresrios6365 pero revise q lleguen los voltages y los masas al rele si estubiera bueno
Where is your wife now, I haven’t seen her for so long
It would be nice...if the computer could tell you precisely where to look for the problem! No they want you to take it to a mechanic and pay from 300.00 on up! Sucks!
Yea