One can use a stirdy knife with sharp tip and with a hammer carefully 'chip' the very first micro puncture to the glossy lackered surface. That way the point of the drill has a center from where to start.
Music and advice equally naff. Just use a special glass/ tile drill tunsten or diamond tipped. Drill through the tile and you can then use a concrete drill for finished depth. When using a tunsten/ diamond drill always cool the bit with water spray to avoid overheating the bit otherwise ii will not last long. Try not to drill near the edge of a tile as it is more likely to splinter if there is a hollow caused by lack of adhesive.
nevím jak ty...ale já si vezmu malířskou pásku..udělám si značku fixem...pak vezmu vrut...a do vrutu klepnu tak, abych napraskl sklovinu kachle..a pak vrtám..
So glad you wore protective gloves! That masking tape could cause a major injury if not handled correctly!
You're right
Thank you very much
You're welcome
VERY VERY GOOD AND INFORMATIVE
Glad it was helpful!
Bună,
Ideea este ffffff buna dar te as întreba dacă în faianță se face în același mod.
Mulțumesc
da
One can use a stirdy knife with sharp tip and with a hammer carefully 'chip' the very first micro puncture to the glossy lackered surface. That way the point of the drill has a center from where to start.
Thanks for advice
Gracias.
Thanks! That's very useful. Nice video and great music. Keep up the good job 😊
Thanks a lot Anna
Your video helped me. Thanks.
Glad to hear it!
Music and advice equally naff.
Just use a special glass/ tile drill tunsten or diamond tipped. Drill through the tile and you can then use a concrete drill for finished depth. When using a tunsten/ diamond drill always cool the bit with water spray to avoid overheating the bit otherwise ii will not last long. Try not to drill near the edge of a tile as it is more likely to splinter if there is a hollow caused by lack of adhesive.
Is this mansory drill?
Yes. Masonry drill bit.
Why not use directly diamond cutter?
The diamond cutter is for bigger holes. Also there are some specialized drill bits but they're expensive for diy work.
@ShiningForce07 you can get reasonably priced drill bits for this job, the methods in the video are wrong and shouldn't be done that way.
nevím jak ty...ale já si vezmu malířskou pásku..udělám si značku fixem...pak vezmu vrut...a do vrutu klepnu tak, abych napraskl sklovinu kachle..a pak vrtám..
Natnij miejsce wiercenia kontówką. Oczywiście delikatnie.
Dzięki za radę :)
None of those methods actually work, that's why you don't show the whole process, that is the wrong kind of drill bit to use as well
Hole too small as plastic plug expands when screwed into. Likely to crack tile
Nothing broke