Landcruiser 300 LED tailgate light kit - Step-by-step install

Поделиться
HTML-код
  • Опубликовано: 23 дек 2024

Комментарии • 13

  • @andyk5473
    @andyk5473 Год назад +2

    Great video for a simple, yet very useful mod

  • @Yingyang846
    @Yingyang846 Год назад +1

    I purchased one from Richards after watching this video as always your explanation is so simple & easy step by step guide. However I snapped the plastic grommet in the middle of the roof, as it was quite hard to get out. It works brilliant, THANK YOU , awaiting your next instruction set up .

    • @austimages
      @austimages  Год назад

      It can be a bit tricky that one. I'd suggest you put some sealant on there and tape it in place until it dries, otherwise you could end up with water entry if the grommet isn't well sealed against the metal.

    • @Yingyang846
      @Yingyang846 Год назад

      Thank you for that tip & very much appreciated. have since done that. Thank God summer is around the corner .

    • @Abh_92
      @Abh_92 11 месяцев назад

      The right way to undo the grommet is from the other side, rises down the roof a bit and undo it from there, otherwise 90% it will snapped or not hold very well and cus leaking.

  • @BaderB-l9g
    @BaderB-l9g 2 месяца назад

    This tutorial is excellent. Thank you.

  • @HammerRocks
    @HammerRocks 7 месяцев назад +1

    An excellent step-by-step installation guide. Well put together. These are the gear I like, OEM looking ones. 👍

  • @mightymike9353
    @mightymike9353 Год назад +2

    Another great tutorial👍

  • @andyreeves1146
    @andyreeves1146 Год назад

    Awesome Video Jamie. I have a GXL which has the rear light. Do you know if this kit will fit?. Cheers

    • @austimages
      @austimages  Год назад

      Not without modification. The GXL has an incandescent light, which has a different connector to the LEDs fitted to the VX +. Richards are unable to find the correct plugs. So you can fit it, but you'd need to manually spice in to the light wiring rather than use the plugs fitted to the supplied loom.

    • @andyreeves1146
      @andyreeves1146 Год назад

      Thanks Jamie, much appreciated

  • @maigen186
    @maigen186 8 месяцев назад

    Many mistakes (at least 3 mistakes) during your installation. Your 300 will be water leak soon. The rubber seal will be a big headache for you as well.

    • @austimages
      @austimages  4 месяца назад

      It's been in for over a year now. No water or dust leaks. All working fine.