Good job! Should run good after rebuild. One tip that I did on all my 700 Yamahas: I bought a $10 Oil Pump Block Off Plate and disconnected my oil injection system. Just pre-mix the oil and gas then you never have to worry about cylinders not getting lubed! Lookin forward to the final rebuild vid!
bro you don’t know how much time you save me . i have a locked motor and cudnt take the expansion pipe off i thought i had to take the screws on the bottom. but i just wiggle it and it’s off
Good job! Should run good after rebuild. One tip that I did on all my 700 Yamahas: I bought a $10 Oil Pump Block Off Plate and disconnected my oil injection system. Just pre-mix the oil and gas then you never have to worry about cylinders not getting lubed! Lookin forward to the final rebuild vid!
Good advice. Definitely planning on that as well
Thank you for the video. I am also going to have to replace the pistons on my 95 wave runner III
you have a video on re installing it . i want to see how you pushed the piston back in there without taking of the whole thing
Looks like a fun project . Looking forward to your next video .
bro you don’t know how much time you save me . i have a locked motor and cudnt take the expansion pipe off i thought i had to take the screws on the bottom. but i just wiggle it and it’s off
Is there a follow up video?
Did you ever get around to finishing it?
Can you help me with a cooling water flow diagram ?
Did you put it. Ack together?
Have you finished this?