Installing a Power-Pole anchor on a Pontoon boat

The crew at MCU preform a quick install of a 10ft Power-Pole Blade Shallow Water Anchor on to a Avalon Pontoon.
Product:
Power-Pole Blade: goo.gl/zzQtxB
If you have any questions please contact us!
Phone: [phone]

[@NJNerve]

At 3:34 you can see while the unit is lowering, there is considerable bounce. He did not use backer plates which means he should be going through the stringers. I hope that he was able to ensure he went through the stringers without taking off that underpinning. Otherwise the anchor is only attached to the decking.

[@floridasaltlife]

Looked wiggly and that bracket needs some more support, maybe a torque arm underneath the deck or gain access to add a good big backer to spread the load and not draw down on the under pinning.

[@dozer8065]

Decent install video.... and i do like this channel. One thing i would point out.... How the pole was mounted threw the wave tamer. Anything that ive installed threw the deck i have always pulled the wave tamer down to have a solid mount threw the deck itself with large fender washers.

[@danielb8455]

Use a heat gun instead of a torch for the heat shrink. That burn on the power wire will cause corrosion within the first season on the water.

[@carlosmurphy4u1]

No long shot so we could see it fully working???

[@led8541]

very cool

[@poorfatman5317]

Why not put two on

[@carlosmurphy4u1]

Who the hell you talking to, the camera man?
You should be looking at ME the viewer, I hate it when they do that.