Hi would it be possible to do this guide for a MK4 2.2 tdci (200bhp) KNBA engine. It's the facelift model that uses the Peugeot HDI engine. I've searched & searched but can't find any guides for it anywhere
Yes I have on stilascop you would see a very sharp drop then rise too high. With out that you just saw high soo after seeing the sharp drop I looked at the fuel filter and all I can say was WOW I'm surprised it even ran. Filter was nearly fully clogged at the moment car seems to have full power and not cut out so 🤞🤞🤞 car is due to have a full service very soon and a full make over stay tuned and welcome ✌️
Have you replaced the manifold gaskets? I’ve heard that it’s better to put new ones as the old ones will not hold properly after removed the manifold. Cheers
It's always best to replace them if your unsure. There is talk of possible removeing the engine and gear box and doing chain cover gaskets a full refresh on oil leaks and a clutch we will have to. Wait and see ✌️
After I used cleaner to get carbon and oil off using a toothbrush I rinsed It in water then used a new clean microfiber cloth the ones that don't malt to dry it all leave for a while or use hair dryer if your worried about any water ✌️
Авто/Мото
Hi would it be possible to do this guide for a MK4 2.2 tdci (200bhp) KNBA engine. It's the facelift model that uses the Peugeot HDI engine. I've searched & searched but can't find any guides for it anywhere
Sure when we have one in next
I'd be checking fuel pressure when cuts out had that on one was high pressure pump
Yes I have on stilascop you would see a very sharp drop then rise too high. With out that you just saw high soo after seeing the sharp drop I looked at the fuel filter and all I can say was WOW I'm surprised it even ran. Filter was nearly fully clogged at the moment car seems to have full power and not cut out so 🤞🤞🤞 car is due to have a full service very soon and a full make over stay tuned and welcome ✌️
Have you replaced the manifold gaskets? I’ve heard that it’s better to put new ones as the old ones will not hold properly after removed the manifold. Cheers
It's always best to replace them if your unsure. There is talk of possible removeing the engine and gear box and doing chain cover gaskets a full refresh on oil leaks and a clutch we will have to. Wait and see ✌️
With what did you cleaned the detergent from the parts ? Water or something dry ?
After I used cleaner to get carbon and oil off using a toothbrush I rinsed It in water then used a new clean microfiber cloth the ones that don't malt to dry it all leave for a while or use hair dryer if your worried about any water ✌️