Muy bueno el experimento, trataré de hacerlo. Pregunta Skill: ¿Que número de alambre es...20, 25? ¿De cuántos ohmios resultó la bobina? ¿Si le agrego más vueltas, podré colocarle un perno más pesado? Gracias y felicitaciones. Saludos
@@skillmake But if i have DC 12V and i want strong solenoid operates at that volt , how can i make it ? i need equation to know how much turns it will be needed and wire and coil diameter too.
PLEASEE How can I make it have these two directions, that it 'opens' and 'closes', I can't make it have these two movements even reversing the load, is it real that it does that or did you do something else for him to make these two movements.
coile magnatise when turned on. That is why the coil attracts metal. He just added a magnet on one side ++ and - - repel and + - attract, so the chinging wires + -. it can move both ways
Curious how many ohms was the coil? I made with hair thin wire resistance is 1030 ohm. At 12 volts shows no signs of magnetism.. Do I have to raise the voltage? When calculating watts it's only 0.13 watts, lower than solar cell power. Probably have to increase the voltage, but how much is proper. Is there a temperature limitation for wires?
Add a spring a on one side...when you connect it to the battery, it will go to one side and comes back when u disconnect it...use a switch that turns off when you leave your hand(like one used for calling bells)
@@skillmake is there an electrical component that can automatically change polarity, so you don’t have to manually change positive and negative of battery
coile magnatise when turned on. That is why the coil attracts metal. He just added a magnet on one side ++ and - - repel and + - attract, so the chinging wires + -. it can move both ways
Great sharing and to make solianoid using coil👍
I f I want to use it to open a small air gate will over heat if power is left on it?
Amazing
can you attach it with amplifier or music player and turned into dura mobi speaker.
For 24 volt operation how many turms of copper wire use...and what size of the wire (swg)
Muy bueno el experimento, trataré de hacerlo. Pregunta Skill: ¿Que número de alambre es...20, 25? ¿De cuántos ohmios resultó la bobina? ¿Si le agrego más vueltas, podré colocarle un perno más pesado? Gracias y felicitaciones. Saludos
How can i more pulling power in small size
Great job ... !!!
👍+sub ... !!!
Regards Paul P.
thanks mr pawel are you like this video
Does it work if you use an insulated wire?
yes it work
You should specifically mention SWG of wire, dia of coil and number of turns.
Lo que interesa es el número de vueltas (que lo explica en el video) y el número del alambre, que es el dato que falta...
How did you calculate the number of turns and the voltage required applying to the coil ? Do you have any equation for making a coil like you did ?
hi mr wadi The thinner the wire and the more turns you use, the better it will work. I used an ohmmeter
@@skillmake But if i have DC 12V and i want strong solenoid operates at that volt , how can i make it ? i need equation to know how much turns it will be needed and wire and coil diameter too.
@@wadib3eed7 I guess around 1200 turn
@@skillmake what is the SWG of the wire?
PLEASEE
How can I make it have these two directions, that it 'opens' and 'closes', I can't make it have these two movements even reversing the load, is it real that it does that or did you do something else for him to make these two movements.
coile magnatise when turned on. That is why the coil attracts metal. He just added a magnet on one side ++ and - - repel and + - attract, so the chinging wires + -. it can move both ways
kalau yang 5 volt bisa tidak
Curious how many ohms was the coil? I made with hair thin wire resistance is 1030 ohm. At 12 volts shows no signs of magnetism.. Do I have to raise the voltage? When calculating watts it's only 0.13 watts, lower than solar cell power. Probably have to increase the voltage, but how much is proper. Is there a temperature limitation for wires?
how too use continum?
how is it possible to change positive and negative if it is a lock system? I need to push it and pull back after a few seconds. please help.
In this method, you actually make a magnet. By changing the positive and negative bases, you can change the direction of the key
Add a spring a on one side...when you connect it to the battery, it will go to one side and comes back when u disconnect it...use a switch that turns off when you leave your hand(like one used for calling bells)
It is wire what?
sir if same number of turn with thick wire(30 swg to 22swg) and other things same, what happen,
magnetic power increase or noting change.
Please answer!!
No
Magnet is necessary?
Yes, a magnet is needed to make the reciprocating motion
How to make it wireless
I wanna connect it to a 230v circuit..so how many turns do i need..
Bro you can use mobile charger for power
@@Footbro911 no bro, it's for something else.. gotta connect it to 230v..
@bioflockfishfarming5785 what's the formula to calculate it
Can we use any size of copper wire?🙂
yes
Coil name
How many voltage?
12v
Wow nic work.
Like+sub 👍
Thank you so much 👍
How does it reverse
Just change the positive and negative of the battery
@@skillmake no it won't work like that is what I have seen unless the core is a magnet also
@@skillmake is there an electrical component that can automatically change polarity, so you don’t have to manually change positive and negative of battery
U can reverse it with a 4 channel relay. And a arduino or hbridge driver
@@thepanther8925 you could also install a spring so it automaticallly closes when no voltage is applied
fungsi mahnetnya buat apa min
How does it reverse
coile magnatise when turned on. That is why the coil attracts metal. He just added a magnet on one side ++ and - - repel and + - attract, so the chinging wires + -. it can move both ways