This is not the right method for repairing such sensitive equipments, the heat sink must be cleaned from dirty thermal paste before placing the new paste, transistor legs must be covered and isolated to avoid short circuit and electrical discharge caused by the dust, gates pulses must be tested with oscilloscope to ensure correct functioning of the gate driver to prevent transistor damage, after that a small layer of transparent warnish is needed to protect the soldered spots from humidity.
Amigo tengo una igual daño el diodo D3 y D4 y no se ve que numero es son los que estan al lado de los igtb son capsula to220 estan en un pequeño disipador si me puedes ayudar que numero es
Thank you very much for the video but please i want to have th circuit diagramme of this MMA 200 . By trying to repaire my owne it will help me reconstitut the part that has been burned . thank you !
I have 1 like that sir but no short fet can it be the driver board and there is alot of dust next to the mosfet can that cause any problem
This is not the right method for repairing such sensitive equipments, the heat sink must be cleaned from dirty thermal paste before placing the new paste, transistor legs must be covered and isolated to avoid short circuit and electrical discharge caused by the dust, gates pulses must be tested with oscilloscope to ensure correct functioning of the gate driver to prevent transistor damage, after that a small layer of transparent warnish is needed to protect the soldered spots from humidity.
why did you took 1 resistor and didnt replace any?
good evening, I would like to know if the diodes you changed in the driver were zener or whisper diodes, thanks
Amigo tengo una igual daño el diodo D3 y D4 y no se ve que numero es son los que estan al lado de los igtb son capsula to220 estan en un pequeño disipador si me puedes ayudar que numero es
60F30A
@@greenshethpor favor si tambien me puedes ayudar con los codigos de los diodos smd (D05-D06) que estan cerca al relay de 24 v
ប៉ុសផ្សារម៉ាកនឹងល្អប្រើអត់បង
The oc light was still on after the repair
Thank you very much for the video but please i want to have th circuit diagramme of this MMA 200 . By trying to repaire my owne it will help me reconstitut the part that has been burned . thank you !
Good tiçhing 👍👍👌👌👌👍👌👌👌👍
Sir the j33 diode...what is the replacement?
Ponle audio
tengo la tarjeta me podrían apoyar armar es igual a la que están reparando
San po ang shop nyo?
Ingco at total ay parihas lang ang board
taga saan ka boss
បងបើដូរហ្វែតហើយដោតស៊េរីគឺផ្ទុះទៀត។តើវាខូចត្រងណាដែរបង
Gud information
Gud information
Gud information