Traxxas ESC green red light flashing and will not run check low voltage detection for LiPo vs NiMH

Поделиться
HTML-код
  • Опубликовано: 11 сен 2024
  • A solid geen esc light is LiPo mode and the car will not run in this mode with a NiMH battery. You need to disable the low-voltage detection in the esc. Go to minute 2:00 for a quick reference although the steps are almost the same for putting it into LiPo mode (start of the video).
    Traxxas ESC green red light flashing and will not run check low voltage detection for LiPo vs NiMH
    • Traxxas ESC green red ...
    Traxxas TQ Throttle Reverse How to Reverse Throttle on TQ Transmitter
    • Traxxas TQ Throttle Re...
    Traxxas TQ Steering Reverse How to Reverse Steering on TQ Transmitter without B-Link
    • Traxxas TQ Steering Re...
    Traxxas TQi Steering Reverse How to Reverse Steering on TQi Transmitter without B-Link
    • Traxxas TQi Steering R...
    Traxxas TQi TSM wobble of death Slash 4-Tec 2.0 3.0 Supra Corvette Factory 5
    • Traxxas TQi TSM wobble...
    Traxxas Drag Slash TQi Transmitter Trans Brake... is it worth it?
    • Traxxas Drag Slash TQi...
    How to Pair Traxxas TQi to TQi and TQ to TQ Transmitter and Receiver
    • How to Pair Traxxas TQ...

Комментарии • 9

  • @chaser1357
    @chaser1357 8 месяцев назад +2

    Im not getting any flashing lights on my Latrax esc or will it let me calibrate.
    The transmitter light will be on while the esc light off. Do I have bad esc?

    • @telecomandorc
      @telecomandorc  8 месяцев назад

      It sounds like it. Have you set the end points?

  • @Dankenstien909
    @Dankenstien909 5 месяцев назад +1

    I'm having issues with the esc blinking red/green when a fully charged 3s lipo is plugged in. works fine with nimh... any ideas?

    • @telecomandorc
      @telecomandorc  5 месяцев назад

      This video should take care of it. You are probably in NiMH mode. You need to switch to LiPo mode.

    • @Dankenstien909
      @Dankenstien909 5 месяцев назад

      @@telecomandorc figured it out.. 3S isn't supported on a Traxxas Rustler with an XL-5 ESC.

  • @chaser1357
    @chaser1357 8 месяцев назад +1

    I am diagnosing but now the esc light blinks or goes off when pressing throttle

    • @telecomandorc
      @telecomandorc  8 месяцев назад

      Have the Tx on. Turn off the esc. Press and hold the power button until the red light blinks. Put fur throttle, it will blink twice, go full brake. It should blink and be set. If not, not sure. It could be the esc.

    • @chaser1357
      @chaser1357 8 месяцев назад +1

      @@telecomandorc yeah it won’t do the blinking so i can calibrate

    • @telecomandorc
      @telecomandorc  8 месяцев назад

      @@chaser1357 Might be the esc. Castle has a nice system. I have videos installing one in a LaTrax Prerunner. Too fast though.