Harvey Woodworking Router Table Unboxing and Install by
HTML-код
- Опубликовано: 9 сен 2024
- Do YOU need a router table system for your workshop? Watch Nick with @KeyWoodworks unbox and setup the Harvey Compass Router Table System into the wing of his Harvey HW110LC table saw!
Check out the full router table system for yourself, link below!
www.harveywood...
Follow Nick at @KeyWoodworks at all the links below!
instagram: / keywoodworks
facebook: / keywoodworks
twitter: / keywoodworks
#woodworking #woodworker #woodworker #tablesaw #harveywoodworking
I have this table and fence. I’m getting started with use but still unsure of all of its capabilities. Will check your channel further for some insight. Thanks for the great and helpful video.
Here's a tip to make installing the extension wing by yourself easier:
Remove front and back rails from your table saw first. It's much much easier to set the extension in place without the rails getting in the way. Then install the legs to the extension wing. It's a lot easier to line up the bolts when the legs are supporting half the weight
could you have put it closer to the table saw by swapping it with the smaller wing extension?
Great video! One day this will go on my HW110S-36P.
Thanks for sharing.
Let’s make it happen! 👏🏼
I’m curious. Can the router table be put on the left side of saw by way of removing the extension wing? I realize it is wider than the wing. My shop configuration requires it on that end as the right side is against the wall. I thought of just turning it around on right however the rounded corners and think it would be awkward if you cannot stand in front of it. Pulling the trigger on new 2 HP with Nickel plate and Big Eye this week. Can’t wait! Thanks
Yes it can!
I saw a Woodpeckers video abt using their fence to use as a jointer by offsetting the sides of the fence. Is this anything you’ve done?
Absolutely our fence has dual face adjustment to be used in this manner 👍🏼
Nice add to the table saw. Could you tell if each side of the router bit the fence can be independently adjusted or is it a one piece across?
Independant adjustment for applications like cutting rabbets!
They don’t tell you when purchasing the table that their fence is the only one that fits!