Great video. My cr10 was fine with pla plus at 220.. but with silk pla at 200 and the bed at 60 it seems to over extrude(?). Small details in the first layer distort and curl ruining the rest. Any hints please?
That is Creality Print, the software that is recommended the CR-10 SE instruction manual. That is actually an older version (v4), the latest version available is 5.1 which looks quite a bit different.
im having hard time printing esun PLA+ with this CR-10 SE. Creality Print just did awful, Cura did quite okay and in Orca I didnt manage to print properly yet.
Hi. For filament changing: after you insert new filament, press Length and set 30-40 mm then press Extrude. It's more convenient. :)
Very good point, thanks for adding to the value of the video!
Hey thanks for posting this! On paper, this looks like Creality's best bed slinger after the new Ender 3 V3
I haven't had the pleasure of using the new Ender yet, but it's on my list for sure! Now I'm even more excited about it. Thanks for watching!
10:17 do not strengthen too much your X axis belt, or it will rip 😅 check the nuts and bolts on your printer and put some grease on the Z axis rods
Great video. My cr10 was fine with pla plus at 220.. but with silk pla at 200 and the bed at 60 it seems to over extrude(?). Small details in the first layer distort and curl ruining the rest. Any hints please?
Silk always needs to be printed hot and slow. I would raise the extruder temp 220-230 and print no faster than 60mm/s. Let me know if that helps.
What program were you in to change the printer settings? I’ve never seen that screen….
That is Creality Print, the software that is recommended the CR-10 SE instruction manual. That is actually an older version (v4), the latest version available is 5.1 which looks quite a bit different.
im having hard time printing esun PLA+ with this CR-10 SE.
Creality Print just did awful, Cura did quite okay and in Orca I didnt manage to print properly yet.
hi will this work with octoprint, thanks
I haven't tried with octoprint, but let me know what you find out 🙂
Hii guys some one can help my creality printer write machine start up in progress so long time i need to make calibration