REBUILDING MY WHEELS WITH RINGLE DUROC 30 RIMS !?
HTML-код
- Опубликовано: 15 окт 2024
- I'm finally rebuilding one of my mountain bike wheels sets with some wider rims, that will support and make my tires less squirmy when lowering the pressure. The way shown in the video only works if your ERD between the new and old rims is within a few mm's or sonof each other. Have you relaced wheels before? Yes? No? Why not? Discuss in the comments or share your ideas.
If you like this type of content, please consider leaving a like, subscribe to my channel, and hit the notification bell.
THANKS FOR WATCHING!
HASHTAGS:
#cannondale #lefty # lefty ocho #vittoria #vittoria tires #vittoria barzo #barzo #project 321 #p321 #shimano #shimano xt #stylo #ergon, #truvativ #mountain bike #mountainbike #mtb #wheel rebuild #wheel relace #ringle #ringle duroc #duroc #duroc 30 #düroc 30 #ringle düroc #ringle düroc 30 #rush #cannondale rush #cannondale 29 #rush 29er #thomson #thomson precision #reserve fillmore #reserve fillmore valves #fillmore valves #tubeless #orangeseal #mtb #mtblife #mtblove #diyrepair #diy
Music by: Onkel Rico (That's me!)
Nice job on your new rims.
Thank you!
Здравствуйте!
Не правильно Вы проверяете натяжение спиц. Это делается до сборки колеса на стенде, чтобы была возможность привести спицы к равномерному натяжению по каждой стороне и если надо, откорректировать колесо. Какой смысл это делать на собранном велосипеде, если возможности регулировки и контроля уже нет?
Good catch👍 I checked the tension as you stated in the truing stand before I had the tires on, but my camera was off. So I only did it real quick with the tires on for the video, but they were still evenly tensioned.🍻
You're ok with that hop?🥴
So far I can’t complain…. Within a mm is ok, especially since It needed a little truing after the first ride anyways. Been straight as an arrow since. A little heavy compared to the old Stan’s hoops, but stronger.
@@Onkelrico a hop is much more bothersome than being out of true. The uneven spoke tension will keep getting worse.
Hop was fixed after the first ride when wheels were re-tensioned and re trued. Straight as an arrow with maybe 0.2mm “hop”. Never had any issues on any of my wheel builds doing it this way. Never even broke a spoke, maybe I’m not riding hard enough….😂🤣