I have two Cantilever beams they are fixed at one end , and joind at one end and free at other end . combined load load 2.5 tons is applied to these beams . Load is in the form of circular steel coil which gives the displacement in Z direction but also at an angle 5 degrees inwards to words each other .
Try creating the lines one by one. The problem could be with the mirror operation. What I did is to cretae just one line in the sketch and do the whole process until the model step. If everything goes well, then I did it with two lines in the sketch, and so on.
![ANSYS WORKBENCH TUTORIAL : LECTURE 01 [ INTRODUCTION ]](http://i.ytimg.com/vi/IMCqGDmOU2I/mqdefault.jpg)
when you are doing (ansys) sir please explain these boundary conditions so people can understand
I have two Cantilever beams they are fixed at one end , and joind at one end and free at other end . combined load load 2.5 tons is applied to these beams . Load is in the form of circular steel coil which gives the displacement in Z direction but also at an angle 5 degrees inwards to words each other .
sir, on solving, I am getting the message, "The type of geometry selected is invalid for this object". Please help.
Try creating the lines one by one. The problem could be with the mirror operation. What I did is to cretae just one line in the sketch and do the whole process until the model step. If everything goes well, then I did it with two lines in the sketch, and so on.
or maybe this could happend due to a mistake when assignig the position of the forces or supports. Because this will modify the ecuations system
Showing " invalid magnitude"
If the force is at angle of 5 degrees how to solve the same problem
Why is the result I get different from the video? The average reuslt I get is 3 times from the video please help
What is RY here?
Why do you use 4 lines for creating a beam? Any logic? Can't we simple use single line