plinth beam & foundation waterproofing with Dr Fixt Bitufix
HTML-код
- Опубликовано: 25 дек 2022
- Dr. Fixit Bitufix is used for providing damp proofing for below ground concrete structures which are above the
water table. The coating is also used as a moisture vapor barrier on block works and concrete surfaces prior to
cladding. This can also be used as the protective coating for built- up roofing systems along with fabric.
Features
} Resists the attack of salts like chlorides and sulphates that are present in the soil.
} Easy to apply
} Cold applied
} Adheres to concrete
} Can be applied in closed or confined spaces
} Water-based
} Non-flammable
} Versatile
} Economical
Method of Application
} The application temperature should be between 5°C to 55°C. Application procedures may vary slightly
depending upon site conditions. The general recommended guidelines for the application of the bitumen
coating is as follows:
1 . SURFACE PREPARATION
} The surface shall be cleaned thoroughly of all contaminants like dust, traces of curing compound, oil and
grease.
} All surface imperfections and protrusions are to be removed and repaired. Structurally unsound and friable
concrete must be removed and repaired with a suitable repair mortar or PMM.
2. PRIMING
} Primer is always recommended prior to coating as it not only penetrates into the concrete pores and seals
the substrate. It also acts as an adhesion promoter for further coatings. The primer coat can be made in the
site by diluting the same bitumen emulsion with 20% water. The primer may be applied by a brush, roller
or airless spray. Allow the primer to dry before any further coats are applied. However, if the primer after
application is left open for more than 24 hours after it becomes dry, clean the surface of any settled dust and
apply a fresh coat of the primer.
3. APPLICATION
} Stir the contents of the drum thoroughly prior to application to remove any sediment. The application can be
done with a roller, brush or airless spray. Apply the coating at a coverage rate of 1-4 m2/Ltr/ coat, depending
on the dry film thickness required. 2nd coat to be applied in a direction perpendicular to the 1st coat
foundation ki waterproofing kese kre complete process of plinth beam waterproofing @shriengineering @drfixit-waterproofingsolut7479 @akhileshbhandari Наука
Very nice
Very meaning full information....
Very nice explained...continue your explanation you will grow a lot
Thanks for lovely compliment..🙏
Bro replay
My appreciation is extended to you
Very informative video. Thank you so much
thanks sir 👍👍
Good
Sir bitufix use krne ke baad brick wall bnane Mai to koyi problem nhi aati hai na..mtlb brick aur bitufix bond bnate hai na
Thank u bhai
Anna water proof bim vesina enni rojulaku veyali
Wterproofing process casting ke kitne din bad karna hai
Urp and bitufix both should be used side by side ?
good job
Thank you sir 🙏
Superb
Thanks.
Sir primer cot ke bad
Base cot kis material ka hota hai
Base coat mai paani se dilute karna hai ya nahi
Do we need to waterproof in pilling foundation
What is days After ?new foundation construction
💃🏻🙏🏿🙏🏿
Thanks Gunjan ji
While laying foundation construction which chemical material is used for anti termite treatment
Imidacloprid 30.5% SC,Name of product: Bayer Premise - for termite control (pre and post-construction)
sir waterproofing ni kar paaye hai brick work start hogya h abhi kaise kre
जो घर बनाते हैं तो उसका बेल्ट घुमाता है उसी में इसको लगाया जाता है
How much pidicrite urp and bitufix is used in per sqm and per sqft
100 bottle
Can we use this for roof top on screeding
No sir
Hii
20 kg me kitna area cover hoga
Coverage aapki 20 ltr me 350 to 400 square/feet tak aa jayegi.
Dr fixit diya hai plinth me uske baad bhi ap jo bataye wo karna padega
Ha ji, complete waterproofing es process ko follow karne k baad hogi, or aapne dr fixit ka lw+ concrete me mix kiya hoga, wo aapki concrete strength dega.
Pr liter price kya padega
125/ltr
Respected sir,you are waterproofing both sides,but what about the bottom side?BE evergreen.
waterproofing makes a barrier between plinth beam and brick wall,
Sir agr coating uper surface per hi kare toh kya kya dikkat ho skti hai😊
@@smit3255 The water will raise up from the uncoated bottom side.
@@smit3255 jab tak surface theek hai to koe problem nhi par agr plaster hi andr se khrab ho kya to waterproofing bi khrab ho jayegi. jada effective concrete or direct mother slab pe hoti hai.
sir kaha mile ga malum kiye nahi mila
Aap online bhi order kar sakte hai. Ya kisi paint shop pe bi mil jayega
nahi mila dilhe me milega
Hardware wale se bat karne pe wo log order se manga dete hai
Sir mujhe 23/28ka naksha chahie
Sorry sir, map ke liye aapko local architect consultant se baat karni chahiye.
Pehle curing karein 8-10 days
It’s good to promote ur local language but unless u re trying to reach u country men who can’t speak English
Bhai chasma Nikal lo video banate time sabko malum hai Tum civil engineer ho,swag bus engineering college tak,duniya bari Kamini hai
Thanks 😂
Very nice
Thanks
Good
Thanks ❤️
Kya hum ise footing par bhi kar sakte hai?
Hanji Kr sakte hai...
Sir muje renovation karwana hai old ghar. ... ghar ko hight karna hai kaise kare