the assistant starts the Genu works as an electric motor, you can see this when the towing tightens so that the electric motor pulls, and otherwise the hoses are too small, etc., etc. and this system doesn't even really work.
Did you see the voltmeter up there showing over 200 volts? There's no universe that there's enough steam reserve in a pressure cooker to put out 200 volts of power under load. It's a total scam.
@@Knight_of_Jericho If it was "good pressure", then he wouldn't be able to just press the line onto the pressure pot. The higher steam pressure is, the hotter it is as well. His cheap tubing would melt, the hoses would be blown off their fittings, and the pressure pot should HOWL with an opening to air if there was enough pressure to generate 220v under a load. The "generator" is just a motor that's plugged in somewhere. This isn't even putting out 5 PSI. Completely fake.
This looks really suspicious. There's no valving to control the double acting cylinders, and he didn't plug the oil ports in the pistons. I'm going to wager that this build is actually fake.
Complete fake. no valves so the team pressure would simply push the LH cylinder to end-of-travel. It's not connected to a generator - it's an electric motor to make the thing go round. At 14 minutes you can see the belt tension is on the underside - i.e. the motor is pulling the 'steam engine' around.
*I make new turbine for family's hydroelectric dam* ruclips.net/video/srYup0Efeyk/видео.htmlsi=na7jQUs7cgDE9A7a
Can you make a gas generator that converts wood gas into electrical energy?
Yes, I can make it
Your the best 👌 ❤❤❤
Thank you very much. Please share this video
@@kinghomemade Yes of course I will do it for you you deserve all the support
@@mahmoudftm333 OK thank you
@@kinghomemadeplease drop your email address for me
This video is produced by my friend in Vietnam. Have you asked my friend's permission to copy the video?
the assistant starts the Genu works as an electric motor, you can see this when the towing tightens so that the electric motor pulls, and otherwise the hoses are too small, etc., etc. and this system doesn't even really work.
Did you see the voltmeter up there showing over 200 volts? There's no universe that there's enough steam reserve in a pressure cooker to put out 200 volts of power under load.
It's a total scam.
Make a load with a motor that cuts wood 500mm in diameter
OK
Scientifically true in this video, It is not exaggerated like the other videos.
Wow Excellent video, like the design, Very Skilled👍
Low RPM, anyway good idea, boost the RPM, for harvesting enough electricity.
Well done 👍 bro, very useful in villages where electricity doesn't reach
a good idea where are you from, my friend?
Very Cool !
@@Fred_Zepplin thanks
Great its working but its in a low speed, need to shift it to high speed to gain much power needed for electricity
One question my friend, can you run a gasoline generator with a 12v engine thanks
Please what is that you put in the pot isn't water
Это вода, просто давление хорошее, дружище это вполне реально, на паровой тяге ездили локомотивы
@@Knight_of_Jericho Ok thanks
@@Knight_of_Jericho If it was "good pressure", then he wouldn't be able to just press the line onto the pressure pot. The higher steam pressure is, the hotter it is as well. His cheap tubing would melt, the hoses would be blown off their fittings, and the pressure pot should HOWL with an opening to air if there was enough pressure to generate 220v under a load. The "generator" is just a motor that's plugged in somewhere.
This isn't even putting out 5 PSI. Completely fake.
U really King homemade...U deserve it.
What kind of generator is that attached to?
Hát ez nagyon nagy ötlet volt barátom😊
Вы Супер!! Я голову ломал,как от солнечного коллектора электрогенератор запитать,Огромное Спасибо!
Good Ok
amazing bro....
❤❤❤❤❤
This looks really suspicious. There's no valving to control the double acting cylinders, and he didn't plug the oil ports in the pistons.
I'm going to wager that this build is actually fake.
It's surprising that how can the input valve press the piston to both sides, if pressure is flowing only one side?
@@n.r.meghwal4386 Exactly, this is super fake. Report it for misinformation.
@@georgeblack589 Agree with you.
One thing is out of mind that, how can the input valve press the piston to both sides, if pressure is flowing only one side?
Sir, one video for solartube making please 🙏
❤
Basically the principle
То есть,от солнечного концентратора из параболической антенны и кусочков зеркал
😂😂
❤
it is normal water
Not different from coal or nuclear
How are you
Ada baiknya kita ikut mencobanya..
It can never work because the piston constantly receives pressure on one side and there is no changeover valve in terms of pressure!! Fake !!!😱😱😱
😊😢 ❤
Another nonsense although appealing.
Complete fake. no valves so the team pressure would simply push the LH cylinder to end-of-travel. It's not connected to a generator - it's an electric motor to make the thing go round. At 14 minutes you can see the belt tension is on the underside - i.e. the motor is pulling the 'steam engine' around.
Can I contact you sir