Design of tension splice
HTML-код
- Опубликовано: 17 окт 2024
- Design a tension splice to connect a 300mmx20mm plate with a
300mmx10mm plate. The design load is 500kN. Use 20mm diameter bolts.
@simpleciviltamil7937
Channel link: / @simpleciviltamil7937
Playlist link:
• CE8601 DSS Reg-2017
#Design_of_tension_member
#design_tensile_strength
#design_of_tension_splice
#welded_connection
#Butt_weld
#fillet_weld
#design_of_lap_joint
#dss
#CE8601
#CE3601
#Design_of_bolted_connection
#IS800
#steel_table
#design_of_butt_joint
#design_of_connections
#Limit_state_method
#youtube
#google
#insta
#trending
#tamil
Thank you
Sir double cover butt joint na mattum bolt values a double pannikanum, lap joint ku thevailla right?
S
Sir lug angle video ellaiya
Why 12 bolts given while we get 6 bolts in calculation, should it be doubled always
Please check the procedure video bro
Sir dsse problems podunga sir
Enakku puriyala?
@@simpleciviltamil7937 neriya sums design of steel structural elements la podunga sir
Sir intha sum la do=22 eppadi vanthuchi
Thanks for your support bro , Dia 20mm naa dia of hole 22 mm thaan bro, pls watch introduction video, this is why I always suggest to watch introduction videos bro, watch introduction to connection video bro or u can see the table no 19 page 73 in IS 800, there it is mentioned clearly
sir tension member la lug angles vaichu sum soli kudnga sir plse
Ok sure, u can expect that on Monday
I checked with 8 University questions paper which I have, in that there is no problem were asked from lug angle method, so if u give the question in lug angle, it may useful to me to solve. You can type that question in this comment section bro
@@simpleciviltamil7937 A tension member of a roof thruss carries a factored axial tension of 430KN . Design the section and it's connection ,
i) without using lug angle
ii) Using lug angle.
@@benileshrajb965 thanks for your valuable response bro, sure i will make a video on this and let you know ASAP.
@@simpleciviltamil7937 Good Work bro...🍀