Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
I was wondering of anyone was going to think to design something like this....how did it hold up?
Hello, Thanks for the tips. Do you mind sharing the Vcarve file for this?
It's on our website: mountainmakers.com
Awesome idea! I can’t for the life of me figure out how to get a tool profile for the same drag knife in vectric! 😫Any tips you could give?
Sorry for the delay. Here's how I have my tool set up, as an End Mill in my Vectric tool database: Diameter=0.125", Pass Depth 0.125", Stepover 0.0125" / 10%, Spindle Speed=1, Feed Rate=50mm/s, Plunge Rate=30mm/s
I was wondering of anyone was going to think to design something like this....how did it hold up?
Hello, Thanks for the tips. Do you mind sharing the Vcarve file for this?
It's on our website: mountainmakers.com
Awesome idea! I can’t for the life of me figure out how to get a tool profile for the same drag knife in vectric! 😫
Any tips you could give?
Sorry for the delay. Here's how I have my tool set up, as an End Mill in my Vectric tool database: Diameter=0.125", Pass Depth 0.125", Stepover 0.0125" / 10%, Spindle Speed=1, Feed Rate=50mm/s, Plunge Rate=30mm/s