How To Setup a Roll Race Bike and 200MPH Speedo Coding Unlock, 2023 BMW S1000RR
HTML-код
- Опубликовано: 10 июл 2024
- Want to know how to setup your bike for roll racing? BT Moto shares a mild setup and how to get your bike faster without adding any power, with our 2023 BMW S1000RR.
BONUS: Check the end of this video for how to code your speedo to display over 200MPH
Parts Used on This 2023 BMW S1000RR:
- BT Moto ECU Flash Tuning and Basic Bolt-ons (Motor is 100% Stock)
- BT Moto 1" Lowering Kit
- BT Moto Front Strap Kit
- BT Moto Wing Delete Kit
- BT Moto Mirror Delete Kit
- BMW S1000XR M Endurance Chain
- Dunlop Q5 Rear Tire (200/55/17)
- JT Sprockets 44 Tooth Rear Sprocket
Special thanks to Lee's Cycle in San Diego. They're also a dealer for BT Moto.
####################
CHAPTERS IN THIS VIDEO
####################
0:00 - Introduction to Roll Racing
03:06 - Baseline Speed and 60-130MPH
04:09 - 42 Tooth Speed and 60-130MPH
05:30 - Install New Tire and 44 Tooth with More Wheelbase
12:17 - Final Testing Speed and 60-130MPH
14:25 - Testing Against Other Bikes with @imKay
18:10 - Final Overview
18:58 - Unlock 200+MPH on Your Dash
To purchase tuning or parts, go to www.BT-Moto.com 
Авто/Мото
![Sean Rii, Karyon, Sharzkii - Taungule [My Love] (Official Music Video)](http://i.ytimg.com/vi/eJoMuypbSzQ/mqdefault.jpg)
Now this is how you start your Saturday! 🏁🏁🏁
Always such complete, well explained videos, great job.
I lowered my 2022 S1000RR two inches and didn’t cut anything. I took a heat gun and heated the plastic and pushed it up with the round part of a ratchet enough so it cleared the shock. Very easy to do and does not involve cutting the plastic where there is a hole there.
I really love how stock the bike is❤❤❤.
Great video
Just got my sprocket and chain, going to try this with my FBO 23’ with e85 tune and report back!
Looking forward to hearing this too man. Wanna get a s1k next year 🤝
Why would any of the changes you made effect the speedometer? Isn't the speedo sensor located on the front wheel ABS ring
Great content. It'd be interesting to see if a taller 200/60 tire would allow for an extra 1-2 mph improvement to the top speed.
It does 250lbs rider 2021 S1k 200/60 supercorsa doing 205mph gps bt stage 2 sprint filter and stacks
Is it working for 2020 s1krr M package ?
1. Is the same value 01 70 on a kmh speedometer?
2. Is it possible to code to use navigation, music and Bluetooth together in Racepro mode?
3. Is it possible to code to deactivate the exhaust flap in the menu and automatically close the flap again when you restart?
Thank you for your videos, they are very helpful. ❤❤❤
So what your saying is my 380 lb butt can't be fast? :-( I see this first hand. When a stock Streetfighter with a 180 lb rider is dead even and then kind of pulling me on my 230 hp Z H2. I just sleep at night knowing my BIKE is way faster just not with me on it. LOL!
I am 290lbs and have a ZH2 yes we big guys will never be as fast as a lighter guy but you have to admit the Zh2 moves our lard asses around pretty well!
Lose some weight and you 2 will be flying
@@skywalkerrider775 Oh absolutely! LOL!
Y’all hilarious
Im 215 , 5'8 .. think im perfect on my bike ... Sorry im not shaped like a woman 😂
Where do you get the Beamer utility tool?
Careful out there in Mexico :)
so if i’m stage 1 bren tune, the bimmer utility coding is not needed? or is it still needed to get over 200 mph? too i’ve seen is 192, not sure if that is the cut off or if that’s really how fast it’s hitting
nevermind, kind of getting it now after hearing it needs to be bren flashed as well
Tried this on my 2022 with 17/43 gearing and a 190/55 rear tire.speedo maxed out at 180. Any suggestions?
I went to do this with my 2024 s1000rr and gs 1911 and i found the 1 thru 4 something and 1 thru 4 display speed and it lost me haha any videos with doing this process thru gs1911
I’d love to run roadkill against this bike set up for set up and see how they match up it looks like it pulls hard with that 44 t sprocket
I ran the 44t on my bike and lost top end compared to my 43t sprocket
why did dropping 4 teeth on the rear net u 0.2 seconds should have slowed accel but add top speed ?
Easier to accelerate from 60 with longer gearing
Yeah. I don't understand that either. Unless he started from 1st gear with the 42. It should be slower because it starts from lower rpm. Unless that gearing eliminates the 2-3 shift from 60-130
@@brandonhollis84stock you have to babysit the throttle at a 5k rpm hit. Tire goes straight in the air. Geared longer you just give it 100% throttle and no need to play with the throttle. That along with the slight stretch works wonders
Does anyone here know how to raise the 186mph speedo to
199 mph on a 2016 bmw s1000rr through the gs-911?
What do you need to do to these bikes to beat a twin turbo lambo huracan? My friend just got his lambo build done and I am ready to drop some cash in this bike to beat him with my 24 s1krr
Depends but it’s possible, depending on how much power it has and what speed you race to
will this work on a 2022?
Yes
lean issues?.just bought your 2 inches lowering kit
I had the 2" kit, but put the 1" kit on after a couple of months. The 2" kit is great for roll racing, but completely changed the dynamics with regards to lean angles.
Maximum lean angle will be reduced slightly and the bike will be a little less flickable, but only noticeable if you’re a track guy. If you drop the forks properly (our DIY) video, you’ll be surprised how well the bike feels after lowering.
I should also mention that I have the BT strap kit along with the 1" lowering link. It's honestly the best of both worlds. Strap it down for roll racing, release it for all of your other riding. You also need to still set your wheelie control in your Race Pro menu. That will help tremendously.
@@Naldo_S1K thanks for the inputs..so 1# should be more practical for canyon ridings? @btmoto?thanks
@@XKV0814 yes! 1" drop will work in the twisties!
theres somethign wrong in the draggy pictures you show 4:05 you said 60-130mph but it shows 100-150mph
You’re right. It was a 4.2 60-130 but posted a 4.2 100-150. They were the same time. Editing error on that one. Good catch
Good video but you guys forgot K46 (2015-2019) why you guys must make some videos for it
I want to add BT to my 24’ S1K but it’ll void my warranty 🫨
Don’t request a raised RPM limiter and there’s no reason to void. We’re making a video with a dealer now and asking them questions directly about voids and denials. Stay tuned.
Not correlating to this bike but what's the best mods for a 2024 rsv4 1100 base like exhast and tune? Is a small can bad ?
Would never let that garage touch my bike. Impact wrench for sprocket bolts? Gtfoh
Just say you don't know how to use quality impact wrenches.
@@Charger-ob8yl impact wrenches have no place on a bike you muppet.
@@Charger-ob8yl lol. Yeah that comment made ZERO sense!
@@Naldo_S1K what didnt make sense to you?
@@Naldo_S1K right. Lotta mfers don't turn wrenches and just repeat shi they read on a forum from 1992, out of context.
I just don’t get roll racing. Just me I like the track and canyons.
We like it all, but understand some have preferences
You should try 16/41 and let us know 🫡🙏