Someone should test the accuracy of the conveyor and camera. One test would be to cutout about a dozen 1" circles. Throw those on the conveyor and cut a 1/2" circle out of the center or each of them and measure the resulting ring width to see if it is 1/4" on all sides. Then throw those back on and cut the ring in a circle at 3/4" and see it you get two rings each being 1/8" wide. It could be done with squares in a similar manner or just fine lines repeated to see if the overlap perfectly.
What aspects of this xTool F1 Ultra and Conveyor would you like to know more about?
really useful video, thanks for your revewing.
Thank you so much! Shay
Good review!
thank you so much, Aria!
Batch engraving this solves a lot of repetitive operations, which is nice.
yes,it is suitable for mass producing small crafts
Someone should test the accuracy of the conveyor and camera. One test would be to cutout about a dozen 1" circles. Throw those on the conveyor and cut a 1/2" circle out of the center or each of them and measure the resulting ring width to see if it is 1/4" on all sides. Then throw those back on and cut the ring in a circle at 3/4" and see it you get two rings each being 1/8" wide. It could be done with squares in a similar manner or just fine lines repeated to see if the overlap perfectly.
good idea!