One of the problems of my drone is it just auto lands when I use t for a while prob cause it’s low it’s a smart technique but kinda annoying at times another one is I can’t figure out how do the barrel roll I have done it before but just by spamming stunt and some other stuff
The drone auto lands because it’s low on battery. Fully charge the battery. To do a barrel roll. Press the stunt button on top of the remote then move the right joystick to the left or right.Hope this helps. Thanks for the comment Zek’s
Hi, try this reset the stabilization of the drone. By pointing the left joystick to the bottom left and the right joystick to the bottom right at the same time. On a flat surface while the drone Is on. There could also be some dirt or hair stuck under the propellers. That happened to me once with a smaller drone. Got hair stuck under the propellers and it would not spin until it was removed. Thanks for the comment happy to help.
Try this, If your jet does not take off fully charge the thunderbolt jet X-2, with the included charger. Replace the batteries in the remote. Turn on the jet and remote. On the remote move the left joystick up and down. Once this is done the jet is unlocked and ready to fly. To reset the stabilization place the thunderbolt on a flat surface. And hold the left Joystick to the bottom left and the right Joystick to the bottom right at the same time. Once this is done the remote will Beep and the lights on the jet will flash once. Also check to see if the propellers are not broken or have hair stuck in the motor. Thanks for the comment. Happy to help😃
My drone work fine until it crashed one time and then it stopped working. So I took three plane apart where the battery and wiring was where i saw a wire disconnected from the battery, it looks like a semi-transparent wire, I tried reattaching it and it did not work, I need help
The Thunder bolt jet x-2 toy drone is made out of foam. When it’s flying outside on a windy day the flight stability without gps, will have a lot of drift. If it’s a calm day it’s going to be more stable. The drift can be fixed by using the trim settings on the remote control. The airplane drone can fly inside very stable with some drift. This toy drone does not have a camera. Thanks for the comment.
If your jet does not want to lift up and all the lights are on, try this. Charge the battery of the jet and check the batteries of the remote. Turn on the remote and the jet then pair the remote to the jet by moving the left joystick up and down. Reset the Stabilization by placing the jet on a flat surface. And holding the left joy stick to the bottom left and the right joystick to the bottom right at the same time. once it is done the remote will beep and the lights on the jet will flash once. The propellers could also need to be changed it they are broken. If this does not work try this: On the side it leans from trim the remote control to the other side. Hope this helps. Thanks for the comment. Zek’s
When the drone is in auto orientation mode, the drone will orient to the remote, no matter what direction the drone is facing. The charge time is 120 min. The flight time is 6 minutes. Thanks for the comment.
Before the remote is paired to the jet the light on the top of the jet blinks. If the Thunder bolt jet X2 does not want to pair to the remote try this. Turn on the jet on a flat surface first. Then turn on the remote. On the remote move the left throttle stick up and down once then it should make a sound. this should unlock the drone and it’s ready to fly. Hope this helps. Thanks for the comment.😃
@@Zeks-of7yh I figured out the problem. The USB cable we used to try and charge it wasn't compatible with the battery the Jet used so when we used the USB cable that came specifically with the Jet toy and after it actually charged it connected just fine, thanks anyways and happy holidays.
If the thunderbolt jet X-2 does not want to pair try this. Turn on the drone and remote. On the remote control push the left throttle stick up and down; once you do this the remote beeps and is paired. Happy to help thanks for watching.👍 more videos coming soon. Zek’s
Try this fully charge the battery on the Thunderbolt and replace the ones in the remote. Check the propellers. Pair the remote to the drone by turning on the drone and the remote. Place the Thunderbolt on a flat surface. On the remote push the left throttle stick up and down to unlock the drone. Hope this helps. happy new years Thanks for the comment. Zek’s
@@mariaayala2599 To land the Sharper Image Thunder Bolt Jet X2. Try this on the left joystick of the remote control;pull the joystick down and when the drone flys it will land. The drone also has an automatic landing feature in the remote. You activate it by pressing the flight button on the top of the controller,once to take off and once to land. Thanks for the comment more videos coming soon. Zek’s
@@Zeks-of7yh the drone wouldn’t turn off one of its wings. It finally turned off on its own, I guess due to battery life. Now it charges, but it won’t work at all 😞
The same thing happened to me with one of my other drones. I fixed it by resetting the stabilization. Turn on the drone and the remote. On the remote control push the left throttle stick up and then down. then Hold the left joystick to the bottom left and the right joystick to the bottom right at the same time until it beeps. while the drone is on a flat surface. I also looked at the propellers too to make sure that they are not broken. Or need to be replaced. Also try to trim the remote the other way if this does not work. I hope all this helps. Thanks for the comment. Zek’s
If your drone does not turn on. Try this check to see if the battery on the remote and drone are charged. Then turn on the remote and drone. pair them by moving the left joystick up and down. Also try to reset the stabilization by placing the jet on a flat surface. And holding the left joystick to the bottom left and the right joystick to the bottom right at the same time until it beeps. charge the Thunderbolt bolt with the included cable. Hope this helps. Thanks for the comment. Happy to help. Zek’s
Thank you for your feedback. This video is older about 10 months ago, and I am working to improve the video quality and editing in every video upload. Sorry about that.
When flying in wind the battery life could decrease. It’s best to fly in windless days. charge the battery 120min to fully charge. Also try to charge the Thunderbolt bolt jet X2 with the included charger. Happy to help Thanks for the comment.
![DJI FPV Drone Flight Test Review IN DEPTH + Motion Control & Fly More Kit [How Does It REALLY Work?]](/img/1.gif)
You explained this way better! Thank you for the video
Glad it was helpful. Happy you enjoyed. Zek’s
One of the problems of my drone is it just auto lands when I use t for a while prob cause it’s low it’s a smart technique but kinda annoying at times another one is I can’t figure out how do the barrel roll I have done it before but just by spamming stunt and some other stuff
The drone auto lands because it’s low on battery. Fully charge the battery. To do a barrel roll. Press the stunt button on top of the remote then move the right joystick to the left or right.Hope this helps. Thanks for the comment Zek’s
Thanks for the help I do that next time I use my drone
Everything works but it won't take flight it just turns a little bit then it cuts off well the propeller stopped turning.
Hi, try this reset the stabilization of the drone. By pointing the left joystick to the bottom left and the right joystick to the bottom right at the same time. On a flat surface while the drone Is on. There could also be some dirt or hair stuck under the propellers. That happened to me once with a smaller drone. Got hair stuck under the propellers and it would not spin until it was removed. Thanks for the comment happy to help.
Mine was working now it just beeps when I turn it on. I can’t get it to work? Brand new 1 day old. Ideas?
Try this, If your jet does not take off fully charge the thunderbolt jet X-2, with the included charger. Replace the batteries in the remote. Turn on the jet and remote. On the remote move the left joystick up and down. Once this is done the jet is unlocked and ready to fly. To reset the stabilization place the thunderbolt on a flat surface. And hold the left Joystick to the bottom left and the right Joystick to the bottom right at the same time. Once this is done the remote will Beep and the lights on the jet will flash once. Also check to see if the propellers are not broken or have hair stuck in the motor. Thanks for the comment. Happy to help😃
My drone work fine until it crashed one time and then it stopped working. So I took three plane apart where the battery and wiring was where i saw a wire disconnected from the battery, it looks like a semi-transparent wire, I tried reattaching it and it did not work, I need help
Try this, Take it to Geek Squad at Best Buy’s. And they could help rewire it. Thanks for the comment. Zek’s
how about the flight stability without GPS? optical flow sensor? gyro etc to tackle the plane.
The Thunder bolt jet x-2 toy drone is made out of foam. When it’s flying outside on a windy day the flight stability without gps, will have a lot of drift. If it’s a calm day it’s going to be more stable. The drift can be fixed by using the trim settings on the remote control. The airplane drone can fly inside very stable with some drift. This toy drone does not have a camera. Thanks for the comment.
My plan doesnt go up it leans on one side but doesnt go up and all the lights blink at once 😅 help please
If your jet does not want to lift up and all the lights are on, try this. Charge the battery of the jet and check the batteries of the remote. Turn on the remote and the jet then pair the remote to the jet by moving the left joystick up and down. Reset the Stabilization by placing the jet on a flat surface. And holding the left joy stick to the bottom left and the right joystick to the bottom right at the same time. once it is done the remote will beep and the lights on the jet will flash once. The propellers could also need to be changed it they are broken. If this does not work try this: On the side it leans from trim the remote control to the other side. Hope this helps. Thanks for the comment. Zek’s
Had same issue turns out put wrong blade check blade make sure you have number 1 on the sides number 2 on the front and back
When I click auto Orientation the battery stalls out despite charging it for more than 5 hours
When the drone is in auto orientation mode, the drone will orient to the remote, no matter what direction the drone is facing. The charge time is 120 min. The flight time is 6 minutes. Thanks for the comment.
Do you do review requests?
I am not doing review request right now. Thanks for the comment.
@@Zeks-of7yh Ah ok 👍
Cool
For some reason my jex x is blinking when I try to pair it instead of it lighting up without blinking like the mannuel said, any reason why?
Before the remote is paired to the jet the light on the top of the jet blinks. If the Thunder bolt jet X2 does not want to pair to the remote try this. Turn on the jet on a flat surface first. Then turn on the remote. On the remote move the left throttle stick up and down once then it should make a sound. this should unlock the drone and it’s ready to fly. Hope this helps. Thanks for the comment.😃
@@Zeks-of7yh I figured out the problem. The USB cable we used to try and charge it wasn't compatible with the battery the Jet used so when we used the USB cable that came specifically with the Jet toy and after it actually charged it connected just fine, thanks anyways and happy holidays.
Just show how to pair the drone and remote.
If the thunderbolt jet X-2 does not want to pair try this. Turn on the drone and remote. On the remote control push the left throttle stick up and down; once you do this the remote beeps and is paired. Happy to help thanks for watching.👍 more videos coming soon. Zek’s
The same thing happened to me. And I used Zek’s advice and fixed it, thanks Zek. 🎉 love your content. 😊
Did you fix it?
No se por que de repente mi dron deja de funcionar, en ocasiones si funciona y en ocasines no. Alguien puede ayudarme?
Try this fully charge the battery on the Thunderbolt and replace the ones in the remote. Check the propellers. Pair the remote to the drone by turning on the drone and the remote. Place the Thunderbolt on a flat surface. On the remote push the left throttle stick up and down to unlock the drone. Hope this helps. happy new years Thanks for the comment. Zek’s
How do u land
@@mariaayala2599 To land the Sharper Image Thunder Bolt Jet X2. Try this on the left joystick of the remote control;pull the joystick down and when the drone flys it will land. The drone also has an automatic landing feature in the remote. You activate it by pressing the flight button on the top of the controller,once to take off and once to land. Thanks for the comment more videos coming soon. Zek’s
@@Zeks-of7yh Thanks for the advice I needed it zek.
It won’t turn off!!!!! HELP!!!
Is it the drone or remote that won’t turn off. Thanks for the comment.
@@Zeks-of7yh the drone wouldn’t turn off one of its wings. It finally turned off on its own, I guess due to battery life. Now it charges, but it won’t work at all 😞
My drone takes off but goes backwards
The same thing happened to me with one of my other drones. I fixed it by resetting the stabilization. Turn on the drone and the remote. On the remote control push the left throttle stick up and then down. then Hold the left joystick to the bottom left and the right joystick to the bottom right at the same time until it beeps. while the drone is on a flat surface. I also looked at the propellers too to make sure that they are not broken. Or need to be replaced. Also try to trim the remote the other way if this does not work. I hope all this helps. Thanks for the comment. Zek’s
Mine did the same the front prop needs to be push on the motor all the way did that it flies awesome
Mi dron no prende😢
If your drone does not turn on. Try this check to see if the battery on the remote and drone are charged. Then turn on the remote and drone. pair them by moving the left joystick up and down. Also try to reset the stabilization by placing the jet on a flat surface. And holding the left joystick to the bottom left and the right joystick to the bottom right at the same time until it beeps. charge the Thunderbolt bolt with the included cable. Hope this helps. Thanks for the comment. Happy to help.
Zek’s
Pro-tip,
DONT BOUNCE THE PRODUCT (the controller in this case) UP AND DOWN IN FRONT OF THE CAMERA!!!
Thank you for your feedback. This video is older about 10 months ago, and I am working to improve the video quality and editing in every video upload. Sorry about that.
My batter last like 2 min
When flying in wind the battery life could decrease. It’s best to fly in windless days. charge the battery 120min to fully charge. Also try to charge the Thunderbolt bolt jet X2 with the included charger. Happy to help Thanks for the comment.
Hou. Jey. Mat. Neym. Es. Edgar❤ ay. Jiy t. Want
Much Love to all my subscribers👍❤
This thing is a piece of shit and they scammed me
Thanks for letting me know !!!! Everyone has their opinion 👍
@@Zeks-of7yh sry for being so vulgar I was just really mad and disappointed
No worries.much❤️to all my fans.Zekes