Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
Very good, thanks
How to on vcds acceleration cutter can you help me
What the problem? for me same, not enough power on low rpm. ON: 1224 mbar, 90,3%, OFF: 979 mbar, 9,9%. No sticky vanes, turbo in good condition.
the problem is the map sensor? My VCDS put since 979mbar to 1050, when i repeat the process, it go up 10 mbar more, finally it puts 979 mbar at 9.9% to 1111 mbar at 90.33% i think that the map sensor is broke
Try disconnect clutch pedal switch. Car would stall on takeoff. I replaced switch and it was sorted.
Kupplung +bremsen
Membrane du turbo ne fonctionne pas correctement (encrassé)
Very good, thanks
How to on vcds acceleration cutter can you help me
What the problem? for me same, not enough power on low rpm. ON: 1224 mbar, 90,3%, OFF: 979 mbar, 9,9%. No sticky vanes, turbo in good condition.
the problem is the map sensor? My VCDS put since 979mbar to 1050, when i repeat the process, it go up 10 mbar more, finally it puts 979 mbar at 9.9% to 1111 mbar at 90.33% i think that the map sensor is broke
Try disconnect clutch pedal switch. Car would stall on takeoff. I replaced switch and it was sorted.
Kupplung +bremsen
Membrane du turbo ne fonctionne pas correctement (encrassé)