I had it about a month or so, but it was negligence on my part. When I was running low on ink I didn't put it into vacation mode and flush the head out, I just kept running ink flushes to keep it good even though I had little/no white ink left, and that's why the head went out.
Mine did that after I replaced the print head carriage. I had to adjust the height of the print head over the paper. Mine was too high so I lowered it and that fixed my problem. Tech support was a huge help and walked me through the entire process.
So hopping on this so I did the same and now only prints black tried a print faded off colors and did everything is brand new even dampers to @@CreatedWorkshop
Do you have a video on printhead calibration? My printer distorts the image in the exact same spot every time.
On the side board do you know what lights are supposed to lid up?
Are you talking under normal conditions?
We changed the head, damper, and the stirring stand, my white came one on sheet and then it completely stopped
So now you have no white printing at all? Or is it just printing really light? What happens when you do a nozzle check?
My black will not print and my white has broken lines. Frustrated.
How long have you had your printer before you had to change the print head?
I had it about a month or so, but it was negligence on my part. When I was running low on ink I didn't put it into vacation mode and flush the head out, I just kept running ink flushes to keep it good even though I had little/no white ink left, and that's why the head went out.
My nozzle check letters are blurry, i have rhe color lines but letters look blurry and double, any suggestions ?
That’s not a problem I’ve run into before. I would reach out to support
Mine did that after I replaced the print head carriage. I had to adjust the height of the print head over the paper. Mine was too high so I lowered it and that fixed my problem. Tech support was a huge help and walked me through the entire process.
i have replaced the head and then no ink is coming out do you have any idea what is the matter?
Have you pulled the ink through the waste lines?
@@CreatedWorkshop yes
which ink isn’t coming out? All ink? Or just white?
So hopping on this so I did the same and now only prints black tried a print faded off colors and did everything is brand new even dampers to @@CreatedWorkshop
I have the same issue changed everything. Pulled ink through dampers but when I try to pull ink through waste lines it's hard to pull
I replaced my promt head and it's still doing this. What could it be ??
That’s very strange. It’s possible that there’s a problem with your ink that’s causing the head to be clogged. How new is your ink?
I changed my print head, dampers, tubes and put in new ink. No ink is printing at all.
Have you pulled ink into the dampers? I’m assuming so, but wanted to make sure.