HIBLOW XP and WG Series Rebuild Video (XP-40, XP-60, XP-80, WG-2, WG-3, WG-4)

Step-by-step demonstration of how to replace the filter, diaphragms, and casing blocks (with valves) for a HIBLOW XP Series air pump. Skip-to below:
(5:43) Safety Switch Re-set: (Can sometimes disengage during shipping)
(2:50) Replace Filter
(4:46) Disassemble Pump
(6:29) Remove pump module
(7:36) Replace casing block (with valves) and diaphragms
(12:28) Re-install pump module

[@jcbdiggers1]

Great advice and informative 👍

[@user-eg8cn5ft1o]

Should I install a safety valve and check valve on the tubes between the hiblow and difusers? Or is it protected against pressure increases and back pressure?

[@aymerickdavid5723]

Hello.
My compressor is two years old, I changed the rubber membranes today because they were deteriorated.
Now, after a few hours, I see that the supercharger seems hot to me. Do you have this problem on these models? I never noticed that before, but I don't remember whether it was heating or not. Moreover, I find the air that comes out extremely hot too.

[@hiblowusa4106]

The pumps do feel hot to the touch, but you can usually keep your hand on the top without discomfort for 3 seconds or more

[@firemipspy1198]

Where can I purchase the XP-80 repair kit?

[@justinhawkins3901]

Is there any way you could do a video on programming dual port hiblow 80?