How To Reset A Ford Transmission Control Module - Symptoms of a Bad TCM
HTML-код
- Опубликовано: 27 июл 2023
- In this video we discuss how to reset the ford transmission control module. We talk about why you would want to reset your TCM, symptoms of a bad TCM, and if you can drive without a transmission control module.
🧰 Tools you might be interested in:
amzn.to/3Gt4gC6 - OBD2 Scanner
We cover the following questions and topics:
ford focus TCM
how to reset ford transmission
tcm relearn
what does resetting a transmission do
what is a transmission control module
control module problems
control module troubleshooting
tcm reset
tcm programming
tcm repair
tcm replacement cost
We hope this video was helpful!
⚠ DISCLAIMER: Any information we provide in this video is intended as education. Vehicle Freak and it's operators shall not be liable under any circumstances in case of any injury, damage, or any other accident that may occur. By watching this video, you agree to these terms. Vehicle Freak and its operators may earn from qualifying purchases as an Amazon associate. 
Авто/Мото
Dude, you saved my Ass. 2007 Mercury montego Premier. I was 30 miles out at a job interview, stopped for gas on the way home, and started the car. TCM is dead, and it's stuck in low gear. Then I found your video. The check engine light is still on, but it's shifting right for now. THANKS AGAIN for the video.
I've done this three times, and am thankful for using this reset process. I will be getting the TCM replaced per the latest letter from Ford. Thanks for posting this.
Has the dealership agreed to replace your TCM?
What year make and model is the car u did this one ?
I tried getting the TCM replaced on my 2015 focus. The dealer said it didn't need it . But it needs a clutch replacement for $3,500.
It has been reported that there is a shortage of TCMs.
Thanks for sharing still looking for issues on my 480t transmission on 2005 Cadillac Deville! ☮️USA Texas
Any helpful tips because I’ve done everything
This is a very good video thanks
Thank you so much for this information ❤
Let me try it, informative video, kudos
2013 Escape. My project is trying to disconnect the negative battery cable in order to "reset" the transmission scheme. Will disconnecting the battery neg / ground where it is bolted to the firewall enough to clear out & "reset" the transmission scheme memory settings, or will the cable connected at the negative battery post need to be disconnected too?
Does any of the supply to a 2022 MACH 1 mustang with the 1080 R 10 speed transmission? Any problems I should be aware of or lawsuits? Thank you.
I'm having TCM problems and have to wait to get it replaced. But, when it acts up & goes into limp mode with check engine light on, I do this. Afterwards, I have to start up and shut down the car a few times before check engine light goes off and I can drive normally again until tcm glitches again. This has saved me several times.
Is it work for ford escape 2008
Can I do this on a ‘19 edge st?
Will this work on a 2006 lincoln navigator?
Will this work on my 2010 Ford F150 ? 5.4 V8 I’m experiencing everything you mentioned.
I am IMPRESSED! I got no “alarm” at the end saying Tcm programmed however so far the shifting is SMOOTH!!
Same here. No alarm but definitely worked 🎉
Sames
Great video, this resetting tutorial works for my Ford fiesta, thanks buddy
My 2016 Mondeo had 163000.00 miles on it and the issue I have from around 45000 miles is that it goes into a sort of safe mode where on the dash says seek owners manual , the way I get over this is to pull over as the car will not excellerate as it cannot select the next gear - I will pull over and turn the car off and wait for 20 ish seconds and then turn it back on and it resets the computer or something and then I drive off until it happens again - it may not happen again for thousands of miles or may be just 1 mile - any thoughts guys - Cheers (UK)
Yes this works was Going to call tow truck was able to get home
I have a 2013 Ford fusion SE does anyone know if it's worked for y'all if you have that model
Does the work on a 2000 excursion v10 2wd
It like nothing happened on Ford Falcon. I did it twice. And the a section number 9 alarm complete there is no showing on the screen dashboard.
Worked on a f250 2019
Step one should fully start the engine?? Or just on?
Good
Not working on my Ford expedition what does that mean??
great video, what about a manual transmission module reset?
This works for both
I have a 2016 Ford focus. I’m going to try this hoping it doesn’t make it worse. Right now it’s driving, check engine since I replaced the battery, I can still the faulty shifting happening.
Same thing with my 2015 focus.
It happened after I replaced the battery and now my car won’t reverse
no check engine light since I replace the battery and still have reverse after 108 miles drive time. 2016 Ford focus has 165,000. But every once in a while when starting off it feels like the tire skip.
How did reset go?
And I have a 2160 se focus
2001 Crown Vic 4.6 didn't fix anything 😤
In the video its stated that the engine shouldn't be started when turning on the vehicle to go through the steps, but being that my vehicle has a push button start I can't shift into the required gears wuthout starting the engine with the push button ignition...If it can be done as mentioned in this video, how exactly do I turn on my vehicle without starting the engine with the push button?
Just do not press any pedal.
I did that nothing happened with ford escape
Not working for C Max 2014
Mine shut off at 70 miles per hour going down the road and it said transmission not in park
Didn't work for me
Took my 2010 f150 to ford to troubleshoot 4wd. They said tcm is not functioning. Also said they don't make them anymore. Now what?
Junkyard bro
2016
Hey what error codes did you get?
I got P287b and P2837
It’s not working for me
2010 mercury mariner..didn't work
Doesn’t work on many models. Waisted my time with these type of videos on my 2020 f150. Eventually had a shop reset with computer. You will know when it’s fixed.
my ford ecosport 2017 model suddenly lost its reverse function when my battery drained. can i use this strategy?
Doesn’t work on a 2018 Everest there’s no alarm sound nothing.. so now I panic
How do you relearn the transmission
It’s not happening my ford focus 😢
I did this twice and nothing happened, I have a 2015 Focus SE
I did this also but no luck.
Damn i actually came here for my 2014 ford focus se. It was sitting in snow for 2 months. I go to drive it one day and its completely dead. If you connect cables to it the computer turns on but the engine will not turn over. Soon you disconnect the cables everything completely dies again
@@bocean07 don’t worry just go to a local certified Ford dealer the TCM is under warranty across for every Focus vehicle, Google customer satisfaction program Ford input your VIN# and print the TCM warranty information and head to the dealer, my car got fixed in two weeks with factory parts and I was provided with a vehicle loaner, just be kind and polite with the guys at the service center everything is a slow process at the beginning but it works at the end, remember is the TCM customer satisfaction program.
Same here, but I got a fiesta 😑
Pretty sure this is the issue with my 2015 Focus SE. have a diag tool in the way. Will try this too and let y’all know
Dude goes so fast it's hard for fallow what he is saying
Play it at half speed
I have done this 20 times and it does not do anything
Put it in gear and nothing happens
Yeah, this did fuck-all.
*This guy:*
This doesn't have to mean an expensive trip to the mechanic.
*Ford Focus and Fiesta transmission design engineers:*
Am I a joke to you?
That don't work, you'll need to do a different procedure
Sadly it did not work for my 2014 Lincoln MKZ Hybrid. I wish you had the answer
DAMN SLOW DOWN
Can you talk a little faster !! Um people would like to play the video WHILE they are in the vehicle attempting to do this in real time!! Had to start and stop the video.. So unprofessional.. Didn't work.
next time you run into this issue you can adjust the playback speed to be slower or faster. just click on the settings button (looks like a gear) on the video.
@@spamcam5084 thanks so much for the info.. I forgot about that! :)
Shit don’t work stop the cap
I tried this on my Kawasaki Ninja and it didn't work.
Is this a joke?
I just know Ford is a joke, I wish my mother never bought this godforsaken vehicle 😡
I reset my tcm on an Astra by touching the battery cables together. I then did the learning process. Here is a quick video of it I just did. ruclips.net/video/1rkg6AwmdhI/видео.htmlsi=PGqQsmjUhtDMfUPs
This is a fake procedure. Nonsense!
Does this work with OBD1? On a 1993 Explorer 4.0?