When I worked for Kiewit when we built the Los Vaqueros reservoir up by Vasco Rd up in Livermore Ca they had a team of six 651s and 2 D10 rip cats and 2 D10 push cats. Those guys would back up in tandem in 3rd gear! With 2 10s behind a 651 in that soft dirt they had the it boiling over the top after the can barely touched the ground! It was something else! I ran a brand new 825 compactor on the dam all summer, it was a great time and an amazing experience. Thanks for a trip down memory lane! Be safe out there! 🇺🇸💪👊👍
Thanks, brings back memories of my childhood, my grandfather whose company helped build the Alaskan Highway, and his years after building roads through out the Midwest…
Teamwork at its finest. The timing sems to be right on between the dozers backing up to catch the next pan. Not their first day as operators on this iron .
Yeah, people on here freak out about uphill loading, but gravity tends to pull material into the bowl that way. I'm not recommending trying to load uphill on a steep slope mind you, but depending on the material sometimes it's productive.
Probably, but they may not have an 11 set up as a push tractor. Can't imagine a company as big as this would pay 3 guys to do the job that 2 can do with bigger equipment if they didn't HAVE to.
The question begs with all that dust,why don't all the drivers have enclosed air conditioned cabins, their lungs must be a mess at the end of a shift in that????
I don't think you understand the video, or what's going on here, but yes we always try to load downhill facing the fill, but that's just not always possible. 🍻🇺🇲
When I worked for Kiewit when we built the Los Vaqueros reservoir up by Vasco Rd up in Livermore Ca they had a team of six 651s and 2 D10 rip cats and 2 D10 push cats. Those guys would back up in tandem in 3rd gear! With 2 10s behind a 651 in that soft dirt they had the it boiling over the top after the can barely touched the ground! It was something else! I ran a brand new 825 compactor on the dam all summer, it was a great time and an amazing experience. Thanks for a trip down memory lane! Be safe out there! 🇺🇸💪👊👍
Fulton put a 9l behind a 10 that Rudy was running loaded in 6 seconds
651B's will never leave this planet not still running!!! 💪🍻🇺🇲
Balanced and productive
Love these videos, thank you! I could watch them all day. Yet, another future subdivision where the yards will drain like a cement patio.......
A perfect orchestra of earth moving machines 💪
They are the best
And always will be
The D10 pushing the D10 that is pushing the scraper. Good video, enjoyed it.
Thanks, brings back memories of my childhood, my grandfather whose company helped build the Alaskan Highway, and his years after building roads through out the Midwest…
Thank you for the update. I love all the heavy iron
Cutting uphill, here come the keyboard scraper operators!😁 Great video. Those 631 is are tough little boogers
Maybe they. Are loading up. That. Rough. Stuff. For a special purpose
wow, great movement of two bulldozers very fast to push the scraper 👍👍
Love your videos. They are the next best thing to watching a CAT Power Parade
Good way to keep welders and mechanics busy, surely.
That's a pan spread for you.😅
I love running dozer. Even the ol’ push cat
Teamwork at its finest. The timing sems to be right on between the dozers backing up to catch the next pan. Not their first day as operators on this iron .
Wow!!! Spectacular view and great video !!! Thanks
incredible, I can see the operator spinning his wheels and he is being pushed by the Bulldozer,
Wow double push Cat's! Ive never seen that move before.
That Do make it nice
Very common in California. Bigger loads in less time = lower cost per cubic yard.
@@davidwood1294 In your country do you use this device?
This is some boney stuff
It's like getting the wrong way right
oops, the grade checker set the lasers 1 foot off. regrade entire job, please.
Blame the surveyors. 👍🍻🇺🇲
The guys on the D10’s certainly earn their money. Wonder how many hours the tracks do?
Been There Done That :)
earth MOVING
Rock loads better up hill, rolls back in the bowl .
Yeah, people on here freak out about uphill loading, but gravity tends to pull material into the bowl that way. I'm not recommending trying to load uphill on a steep slope mind you, but depending on the material sometimes it's productive.
It also loads better when they close the apron earlier and do not let some of the load fall out.
Nose up on the scraper
these are very sucsefule they know the job better to push them uphill they diging in a hole uphill both ways they keep bottom on grade easer
Sometimes they dig uphill to pull the tail up otherwise the pit ends up too long..
That is tough digging
Would not want the fuel bill.
What are they dipping out
Was this when they did the dirt work for I-5 or I-10
The 5 and 10 were built in the early 60's.
Housing development
Are you related to Bill
What is this material to be used for
California heat, all that dust and noise, that company really hates the guyw in the open station machines.
I was a operator i have had 6 back surgeries and 1 neck surgery, can you gues why? 😂
Looking at Juicy Lucy maybe
@@dennisholst4322 no, looking at your wife, it sent me into convolutions and ruptured 4 of my discs. But thanks for the concern
Couldn t a D11N or a D11R take the place of 2 of these D10Ns?
Probably, but they may not have an 11 set up as a push tractor. Can't imagine a company as big as this would pay 3 guys to do the job that 2 can do with bigger equipment if they didn't HAVE to.
Actually no. 👍🍻🇺🇲
The question begs with all that dust,why don't all the drivers have enclosed air conditioned cabins, their lungs must be a mess at the end of a shift in that????
You probably have never seen or worked in a truly dusty enviroment to say that.
@@albertogarcia5276It's hardly rocket science with dust related lung diseases causing death but rednecks wouldn't understand that
Seems hard work to load up hill
Balls up hill in Rocks balls
Trying to shuve him into school
Pet rocks for sale
Low budget outfit...No Cabs, Straight Pipe no mufflers Wow...except for a couple of Dozers with cabs. I'm all set I'll, pass on this job...Good video.
Dont worry that jobsite aint for whiners n yankees no ways so u would be safe from gettin hired anyways
Cutting uphill with two dozer pushing where are the push pull scappers turn that cut around and go down hill
push pull in sandstone with a short cut.....riiiiiiiiight.
❤
Shut up
Maybe it's undesirable material
Pushing uphill what are they digging a Kate Smith swimming pool
818,000 people left California & your building a road for what, so they can come back or more to leave.
It's not very fun pushing while being pushed by a cat. You feel like a bobblehead.
Mmmmm.... Im gonna tell Sleepy Joe and Newsome.....this equipment isn't battery powered!!
I guess they never heard that cutting downhill is easier and faster. Typical California.
Uphill that’s a no no and rear push cat should pickup next scraper 🤦
I don't think you understand the video, or what's going on here, but yes we always try to load downhill facing the fill, but that's just not always possible. 🍻🇺🇲
@@Control-Alt-Delete619 exactly....if you are digging a hole with scrapers you are gunna go uphill in the cut at some point
@@Gavin84wThank you. How are you going to cut out a pond without going uphill at some point?