Seadoo Spark Misfiring And stalling fix
HTML-код
- Опубликовано: 13 сен 2024
- In This video I’ll show you how to pop the top off of a Sea-Doo spark 900 ace
The one that I showed in the video is a Sea-Doo spark tricks they both had the exact same issue I pulled them apart diagnosed what was wrong by: fuel injectors and spark plugs.
Fixed The misfire the cause was rusty spark plugs
I just did the same thing to my 15' spark. It sat in the garage for a whole year, so when I went to the lake this season, the motor was running rough and it would not rev past 5900 rpm... popped the top off, installed a set of fresh plugs, and bingo! 8000 rpm again! Great video...
Awesome video. I had my spark parked for 2 years. Sounding about the same. Can't keep the rpms steady. I especially liked how you didn't remove the hull all the way. Thanks!!
Being able to test the injectors like this saved me so much trouble shooting
Thanks for watching! Glad it helped!
These videos are turning out so good
Awesome, Thanks !!!
Mine has the original plugs, also 40hrs, i went to change them, and they were literally finger tight 😂
🤦🏻♂️
Do you not need the water running into the back when you're starting and engine running?
You don’t have to if it’s for a very short period of time.
No more than 20 seconds or so.
You are suppose to start it after pulling it out of the water and rev it to clear water out of the system
Love you damn
Mine is 8 year old no problems
Do all 16 sparks have sport mode? How did you set that?
No the 60hp models don’t have sport. You hold the red button down below screen for couple seconds at most.
What do you do for o.t.a.s failure ?
Have to get it scanned
I have a 22’ and maxes at 8000 rpm’s for ab 60 yards then drops instantly to 6000 rpm’s
Yours is the 60hp? Or 90?
this is my brand new 22trixx? is this misfiring ?
These in the Video are misfiring
Ok..ok...1 min into vid and i hear " IMPACT"...PLZ GUYS..NEVER USE IMPACT FOR PLUGS..REMOVING OR PUTN IN!!!
🤣 trust me these are known for breaking off I used it to pull the little bolts holding coils in