Factory Reset of ABB REF 630 Feeder protection relay (ENGLISH AUDIO)
HTML-код
- Опубликовано: 20 окт 2024
- This video will help you with the process of Factory Reset of ABB REF 630 Feeder protection relay.
This video will take you on the hand and shows you the way to install the 630 SUT Lite, then prepare the REF630 for communication, and the for file transfer, finally you will use the 630SUT for resetting to factory sets the REF 630.
This video is not intended to substitute the official ABB documentation, instead is a demonstrative element to help you to speed up your learning experience.
Prof. Francisco Gonzalez-Longatt fglongatt@fglongatt.org
Thanks,ABB for the strong collaboration and support.
Very good
Thanks so much!!!
Thanks for the wonderful videos I coming to you asking you for a solution
My issue is when I have an any a detection fault on the REF 630 I can't lance any commands from the SCADA driving center except in an the case where an employee come into the substation and proceed to default acknowledgement
In front of the relays REF 630 so in conclusion I want to tell you now in my relays there is a condition to make a maneuvre (close circuit breaker ) from the driving center the condition is acknowledgement default if you have a solution for this kind of issue I will be thankful for you to tell me
I need to use this software??? Can I use PCM 2.9 and install package ref630? with updated manager?
If you want to do a Factory reset you must contact ABB technical personnel, they can assist you with that. Yes, you will need 630SUT, I am afraid! Please, contact ABB representative at your country. The reset but be done by DA level 3 professional
Hola como se puede hacer un reset de fabrica a un ref610? Gracias
Hello
It's great job and I would like to ask how can I follow the interlock by porttable and what's meaning a red colour and blue.
Hi
I need your help
Reconfiguration file for REF630 version1.1