⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: ruclips.net/user/AutoRepairGuys ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
My step daughters car has a rough idle and shakes quite violently. It has trouble speeding up when i step on the gas too. I changed the spark plugs, got new coil packs, got a new ecu/ecm and had it reprogrammed/reflashed by a dealership and it still does the same thing. I just ordered this pcv valve so hopefully this fixes the issue. We're in desperate need of getting this car to run!!!! Thanks so much for your videos they are very informational and appreciate you guys' dedication and hard work.
my 2013 dodge dart 155,00 miles has [1] low oil pressure message [2] when i was headed for the repair shop it now has a large engine oil puddle? 🧐 please help. thanks
I have a 2014 dodge dart gt and it has 130,thousand miles just got it and replaced motor mounts and the car was running super smooth but now it started shaking like it has an air leak somewhere and the motor vibrates like when it had bad mounts will this might be the issue?
hello! i have a multi air engine in a crysler 200. Multiple mechanics can not figure it out. In the morning it will run rough (3 cylinders) for 6 or 7 minutes and then it will run fine after that time for as long as i want to drive it. If i stop it for an hour or so then same thing happens.. I have to wait for those 6/7 mins of idle running or it will only run off of 3 cylinders. if i turn it off & wait for a few mins and start it back up, allow 6/7 mins idle then its ok.. any ideas at all? Please help.. my car :(
Same issue in my 1.4. fairly certain it's the PSV valve seals.When it's warm, they expand & it runs fine. When its cold (low 60's or under) they contract & it misfires until the engine warms up.
⛐ Check out our Garage to see what tools we use and recommend:
www.amazon.com/shop/worldmechanics
⛐ Subscribe and hit the notification bell by the subscribe button for new videos: ruclips.net/user/AutoRepairGuys
⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
Just changed mine on the 2.0,it had oil in the thredding,i was wo dering why too,now i know why,and the shaking has calmed down a lot,grate vid
My step daughters car has a rough idle and shakes quite violently. It has trouble speeding up when i step on the gas too. I changed the spark plugs, got new coil packs, got a new ecu/ecm and had it reprogrammed/reflashed by a dealership and it still does the same thing. I just ordered this pcv valve so hopefully this fixes the issue. We're in desperate need of getting this car to run!!!! Thanks so much for your videos they are very informational and appreciate you guys' dedication and hard work.
Did that fix it?????
Hello! How are you doing? Were you able to fix this thing?
@@dadinagasai2263 yes it turned out to be the head gasket needing replaced!
Where is the air idle valve?
I'm having idle issues.
Once giving throttle it smoothes out!
Advice please.
A bad pcv valve? Thanks in advance yall rock!!
Take a shot everytime he says «guys». Good luck XD. No seriously thank you, very well explain, your videos are gold!
Well explained, nice to hear such quality info.
One question though, is blocked pcv Valve the reason for blowing gases through opened oil cap?
Yes the gas, smoke is building up in the crankcase
Amaaaaaaaaaaaaaaaazing
my 2013 dodge dart 155,00 miles has [1] low oil pressure message [2] when i was headed for the repair shop it now has a large engine oil puddle? 🧐 please help. thanks
Can a stuck Open pcv valve cause turbo issues. Because of vacuum problem.
I have a 2014 dodge dart gt and it has 130,thousand miles just got it and replaced motor mounts and the car was running super smooth but now it started shaking like it has an air leak somewhere and the motor vibrates like when it had bad mounts will this might be the issue?
how you fixed that shaking? My car is doing the same can you please help me out
hello! i have a multi air engine in a crysler 200. Multiple mechanics can not figure it out. In the morning it will run rough (3 cylinders) for 6 or 7 minutes and then it will run fine after that time for as long as i want to drive it. If i stop it for an hour or so then same thing happens.. I have to wait for those 6/7 mins of idle running or it will only run off of 3 cylinders. if i turn it off & wait for a few mins and start it back up, allow 6/7 mins idle then its ok.. any ideas at all? Please help.. my car :(
Same issue in my 1.4. fairly certain it's the PSV valve seals.When it's warm, they expand & it runs fine. When its cold (low 60's or under) they contract & it misfires until the engine warms up.
This guy's English is giving me a stroke